Artison RCC600-SM Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Amplificador Artison RCC600-SM. Artison RCC600-SM 13 páginas. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Também para Artison RCC600-SM: Manual de instalação (19 páginas)

Imprimir página

RCC 600 SUBWOOFER AMPLIFIER (RCC600-SA)

The RCC 600 Subwoofer Amplifier can be installed into either cabinetry, on an equipment

shelf, or it can be rack-mounted into a standard 19" Equipment Rack. In any installation be sure

to provide adequate ventilation around the amplifier.

The RCC600-SA has two simple and conveniently placed mode settings. The Music

Mode or Movie Mode user controls are located on the front panel for selection based on the

source material. The Mode settings, Volume and Power Controls of the RCC600-SA can be

accessed via IR codes. The remote included with your unit can be downloaded into a learning

remote or HEX Codes are available on the Artison Web site. The Front Panel of the RCC600-SA

has an IR Receiver and there is a second hard wired feed thru jack that can be connected to an

integrated control system on the rear panel. Each control is described in detail below.

RACKMOUNT INSTALLATION OF THE RCC600-SA

Remove the attached feet of the amplifier.

2. Attach the included rack-mount ears to the front sides of the RCC600-SA.

3. Mount into the 19" equipment rack, the amplifier will occupy 1.5 RU.

4. If installing two RCC600-SA then the rack-mount ears can be flipped to accommodate the two

amplifiers in 3 RU.

RCC600-SA REMOTE CONTROL

The remote control has the following functions:

ON/OFF - This will toggle between Standby Mode (Amber Halo) and ON (Blue Halo).

2. MUSIC MODE – This selects the MUSIC MODE EQ. When active it will have a Red Halo

added to the Blue Halo.

3. MOVIE MODE – This selects the MUSIC MODE EQ. When active it will have a Red Halo

added to the Blue Halo.

4. GAIN – This will raise and lower the volume of the amplifier. A remote or the Gain Knob

on the front panel can both be used to raise or lower the bass volume.

control is configured so that the "last used" device setting will be remembered by

the amplifier.

NOTE: The gain