Artison RCC600-SM Manual de instalação - Página 12

Procurar online ou descarregar pdf Manual de instalação para Amplificador Artison RCC600-SM. Artison RCC600-SM 19 páginas. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Também para Artison RCC600-SM: Manual de instalação (13 páginas)

Imprimir página

_ - - EQ MODES - - - .

fI'J

C~R"~

JMITO EO

MIC

°O@

1. AUTO EQ MIC - This is the input jack for the ARMC Microphone.

2. Switch Settings - Select either:

a. BYPASS - ARMC not active.

b. AUTO EQ. - ARMC active. Will remember the last measured room mode sequence

and settings.

3. BLUE LED STATUS INDICATOR

a. Continuous Short Flash - Switch in AUTO EO setting, ARMC not yet saved. Since

the amplifier leaves the factory with this function having been tested the LED should

not flash continuously even when the switch is set to the AUTO EO position. NOTE: It

is important that you do a room mode set up using the supplied microphone at

your normal listening position if you plan to use the amplifier in this setting

b. One Long, Two Short Flashes - Amplifier Error, Shorted Audio Outputs. Remove

the speaker wires from the amplifier and use an ohm meter to check for shorts

in the line.

c. One Long, Three Short Flashes - Over Temperature Indicator. Be sure that the

amplifier has adequate ventilation. If the situation continues to exist contact

Artison.

4. Calibrate Button - Place the supplied microphone in the desired listening position and

plug it into the AUTO EO MIC input jack. Press the button for a few seconds to initiate

ARMC sequence.