Artistry In Motion Big Shots Manual de operação e manutenção - Página 5
Procurar online ou descarregar pdf Manual de operação e manutenção para Equipamento de DJ Artistry In Motion Big Shots. Artistry In Motion Big Shots 12 páginas. Wireless transmitter and receiver
Também para Artistry In Motion Big Shots: Instruções de carregamento e disparo (2 páginas)
Imprimir páginarequires that the antenna be positioned on or near the ground plane, or adjacent
to metal or wire mesh, then the antenna should be replaced with our 6' antenna
extension. (Under those circumstances, please call Artistry In Motion for
technical support.) The Big Shots® Frame does not interfere with the function of
this system.
1.01 THE POWER, ARM AND CHANNEL SWITCHES.
These toggle switches are located on the topside of the enclosure. The
"POWER" switch turns on and off the battery power to the receiver electronics.
The "ARM" switch has "Safe" and "Armed" positions. In the "Safe" position, the
Big Shots ® Cannon cannot be fired. The "CHANNEL" switch allows the user to
select either "CH A" or "CH B" as the operating channel for the receiver. This
allows for two queues in the standard system.
receiver always be powered up in "Safe" mode if a device is already
connected to a cannon. The operator can then verify that the green
"BATTERY" light does not indicate that any radio reception is occurring
before arming the receiver.
1.02 THE "BATTERY" INDICATOR.
While the power switch is on, this green indicator, located on the topside of the
enclosure, will flash intermittently in bursts of one, two, or three flashes at a time
if there is sufficient 12V battery voltage input to power the receiver. If no flashing
occurs, the battery must be replaced or recharged before the receiver can be
used reliably. Three flashes per burst indicate that the battery has full capacity;
two flashes indicate that its capacity is beginning to diminish, and one flash
indicates that it is near minimum charge, in which case it should be replaced or
recharged immediately after the current use.
The green "BATTERY" indicator will light while a signal is being received that
matches the selected digital address and system firing code. This feature is
useful for warning of reception of firing signals before the arm switch is turned on.
1.03 CONNECTION TO THE BIG SHOTS® SOLENOID VALVE.
Connection to the Big Shots® solenoid valve is achieved through the three-pin
connector located at the top of the enclosure. A dust cap protects this connector.
The connector is keyed, so there is only one way to insert the plug into the
receptacle. After insertion, the locking nut on the plug should be rotated
clockwise 180 degrees to lock the plug into the receptacle.
1.04 THE POWER SOURCE.
All power is supplied from an internal 12VDC power source. The power source
used is a sealed lead acid battery. This battery should only be recharged using
the battery charger sold with this system. Using other battery charges could
result in over charging the battery that could result in destruction of the Wireless
Big Shots® Receiver.
Artistry In Motion, Inc.
Tel: 818.994.7388
Ver 08/20
19411 Londelius Street, Northridge, CA 91324
Fax: 818.994.7688
Website:www.artistryinmotion.com
It is recommended that the
Page 5