CustomWorks Dominator Modelo - Página 12

Procurar online ou descarregar pdf Modelo para Carro de brincar motorizado CustomWorks Dominator. CustomWorks Dominator 17 páginas. 1:10 scale 4wd dirt oval car kit

Imprimir página

Inner Panels

-Parts for

Bag E

9045

Dominator Inner Panel

- Cut the 9045 Inner Panel directly on the trim lines making the main panel (shown right) and the front panel (shown left). In

the diagram below the darker areas are the panels, the lighter areas are to be removed.

FRONT PANEL

STEP #1

STEP #2

- Thread the 5280 Hole Head Screw into the lowest and most forward hole in the back of the

servo mounts.

-Make (3) 13/64" holes on the dimples of the MAIN PANEL. These holes will saddle over the

Hole Head screws on the chassis.

- Remove the "X" area so that the Inner

Panel may saddle over the motor wires

running from the speed control to the

motor.

*ALWAYS USE THE INNER PANEL*

Misc...

Servo Alignment:

your radio so that the servo saver and control link make a 90 deg angle as

shown. Adjust the length of the link so that the 3647 Steering Pivot is centered.

Lastly using the End Point Adjustments or Travel function in your radio, set the

servo so it can only move the same amount LEFT and RIGHT as the steering

components. The steering travel should be at 100% at this time. Failure to do

this will result in damaged parts or servo!

Radio Locations:

Shown is the suggested mounting locations for the

reciever and speed control. It is possible to re-arrange the mounting location of

the servo using the remaining holes in the Radio Tray to move this weight

further rearward.

Electronics Removal:

remove the (2) motor screws and the (3) screws for the Radio Tray. Disconect the

servo control link and all electrical components can be set aside.

Body Mounting:

The best body for the Dominator is the CustomWorks

#9016 Paducah Latemodel. Mount the body with the front wheels centered on

the wheel cut-outs. Ideal spoiler length is roughly 1.5". Suggested body height is

with the body clips in the lowest most hole in the front and highest in the rear.

Qty 1

9038 Qty 4

Body Clip

THIS TAB TUCKS IN BEHIND FRONT

SUSPENSION MOUNTS

REMOVE

THIS EDGE MOUNTS

OVER AND FLUSH

WITH BOTTOM OF

THE RIGHT SIDE OF

CHASSIS.

- Attach the Main Panel to the

chassis and use 9038 clip to fasten.

Center your servo using the sub-trim settings within

To easily remove all electronics for cleaning,

1:1

5252

Qty 2

5280

4-40 x 1/4 BH Screw

4-40 x 3/8 HOLE HEAD

REMOVE

1:1

Qty 1

MAIN PANEL

STEP #3

- Make (2) 1/8" holes on the

dimples of the FRONT PANEL

and mount it to the chassis

using (2) 5252 Screws.

SPEED

CONTROL

RECEIVER