CUTRA Wondercutter Manual de instruções - Página 3

Procurar online ou descarregar pdf Manual de instruções para Cortador CUTRA Wondercutter. CUTRA Wondercutter 10 páginas.

handle indicates that the cutter is vibrating.

04.

When used for more than 10 minutes, the Wondercutter will stop operating and return to Stand-

by Mode to allow cooling.

The green LED on the handle is off while cooling. The cooling condition

is call the Stationary State.

While in the Stationary State, the Wondercutter can be turned on again by holding the button on

the handle. However, to ensure proper performance, allow the Wondercutter to cool for several

minutes before returning to operation.

If the Wondercutter reaches extreme temperatures it will return to Stand-by Mode to allow cooling.

04 Methods of use

Status explanation

Stand-by Mode

The LED turns green when the main body is turned on.

The remaining battery can be checked on the LED of face panel.

* The green LED on the handle is off.

* The Wondercutter will turn off automatically after a beep when not used for more than 10

minutes in the Stand-by Mode.

Up and Running

Vibrations on (pressing the handle button)

* The green LED on the handle is on.

High temperature stationary state

The product enters high temperature status after being used for 10 minutes. To prevent the product

from overheating, it automatically stops operating after using for 10 minutes and turns into the Stand-

by Mode.

* Use the product again after cooldown (more than 10 minutes) for safe use.

Stand-by after buzzer sound

The continuous production of 40,000 vibrations per second generates high temperature vibration, and

eventually will reach high temperatures and the Wondercutter will return to Stand-by Mode to cool. .

* After allowing the Wondercutter to cool, return to operating by holding the button on the handle.

Not allowing the Wondercutter to cool properly will eventually cause a circuit overload which will lower

the performance and power.

* A Loose setscrew of the blade or overload on the blade produces will the Wondercutter to Stand-by

Mode. To tighten the screwset, turn off the power, tighten, and restart.

05 Methods of use

* Checklist before Use

- Check if the device is fully charged.

- The level of charge will impact the power and performance of the Wondercutter. Fully charged