Cutting SQ50E Manual de início rápido - Página 5

Procurar online ou descarregar pdf Manual de início rápido para Ferramenta eléctrica Cutting SQ50E. Cutting SQ50E 7 páginas. Pipe threading machine

2. Mark the pipe at the desired length if it is being cut to length.

3. Insert the pipe into the Threading Machine so that the end to be worked or the cutting mark

is located about 12 inches to the front of the speed chuck jaws (Fig 1).

4. Insert workpieces less than 2 feet long from the front of the machine. Insert longer pipes

through either end so that the longer section extends out beyond the rear of the Threading

Machine.

Tighten the rear centering device around the pipe by rotation of the handwheel at the rear of

the Threading Machine. This prevents movement of the pipe that can result in poor thread

quality.

6. Secure the pipe by using repeated and forceful counterclockwise spins of the speed chuck

handwheel at the front of the Threading Machine. This action "hammers" the jaws tightly

around the pipe.

Installing dies in die head

Relevant parts' name, please refer to the photos within this

manual.

1. Place Self-Opening Die Head flat on bench with numbers UP.

2. Make sure trigger assembly is released.

3. Loosen clamp lever.

4. Pull lock screw out of size bar slot so that roll pin in lock screw

will bypass slot. Position size bar so that index line on lock screw

is all the way to the end of REMOVE DIES position.

5. Remove dies from die head.

6. Insert new dies to mark. Die numbers 1 through 4 must agree

with those on die head.

7. Rotate cam plate until roll pin on lock screw can be positioned

in slot. In this position dies will lock in die head. Make sure roll

pin points toward end of size bar marked REMOVE DIES.

8. Adjust die head size bar until index line on lock screw is

aligned with proper size mark on size bar.

Fig 1

Pipe setup

Fig 2

Layout of die head 1/2"-2"