Cutting SQ80C1 Manual do operador - Página 6

Procurar online ou descarregar pdf Manual do operador para Equipamento industrial Cutting SQ80C1. Cutting SQ80C1 7 páginas. Pipe threading machine

Cutting Pipe

1. Swing reamer and die head to UP position.

2. Move pipe cutter DOWN onto pipe and move carriage with handle to line up cutter wheel

with mark on pipe.

3. Tighten cutter feed screw handle on pipe keeping wheel aligned with the pipe.

4. Grasp the pipe cutter's feedscrew handle with both hands (Figure 5).

5. Switch on to start machine.

6. Tighten the feedscrew handle slowly and continuously until the pipe is cut. Do not force the

cutter into the workpiece.

7. Turn off the switch.

8. Swing pipe cutter back to the UP position.

Reaming Pipe

1. Move reamer arm into DOWN position (Figure 6).

2. Switch on to start machine.

3. Advance reamer into pipe and complete reaming by exerting pressure on handle.

NOTE! Do not apply excessive pressure on handle.

4. Return reamer to UP position.

Removing Pipe from the threader

1. Turn off the switch.

Fig 5

Pipe cutting

5. Turn off the switch.

Fig 6

Pipe reaming