ALUZ ZIBI A1 Series Manual de instruções de instalação - Página 11
Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento de iluminação ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 12 páginas. Surface zuco pivot bios illuminated
Também para ALUZ ZIBI A1 Series: Manual (11 páginas), Manual (13 páginas), Manual (11 páginas), Manual de instruções de instalação (11 páginas)
Imprimir página1
Determine number of reflectors needed. Reflectors are available in 1', 2', 3', or
4' increments. Specify total length of reflectors needed.
2
Position reflectors on luminaires.
3
Install 3 set screws on each reflector to secure in place.
Do not over-tighten set screws
Set Screw
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard RGBW
(A1-ZIBI-STN-RGBW)
Reflector
866.ALUZ.LTG | 714.535.7900
4
If applicable, connect disconnects between luminaires. Slide shrink tube over
connectors and apply heat. The shrink tube will shrink down, sealing the
connectors. Apply silicone around sealed connectors for a stronger seal.
5
Mount luminaires at least 12" away from the wall.
Page 11 of 12
Reflector (A1-ZIBI-STN-RE1)
Shrink Tube
2"
Apply Heat
12"
Min. from Wall
Installation Instructions
4 / 29 / 2022 / Rev 2