Alvarion BreezeACCESS 900 Nota de lançamento - Página 2
Procurar online ou descarregar pdf Nota de lançamento para Hardware de rede Alvarion BreezeACCESS 900. Alvarion BreezeACCESS 900 3 páginas. Breezeaccess ii / mmds / v / 900 spectrum sweep
Também para Alvarion BreezeACCESS 900: Especificações (2 páginas), Nota de lançamento (6 páginas)
Imprimir página1. Introduction
The BreezeACCESS Spectrum Sweep Firmware is a special firmware version based on version 4.5
for the BreezeACCESS II/MMDS/V/900 Family lines that implements Spectrum analysis feature. This
feature is intended to sweep the applicable frequency spectrum and gather real time information about
the signal strength levels and false alarms being detected by the modem, thus helping to determine
the duty cycle and the level of interference from co-located radio systems operating in the same
frequency range.
2. BreezeACCESS Spectrum Sweep Features
Spectrum Analyzer
•
Sets the device in a passive spectrum sweep state to gather information per frequency, including:
o Average Signal Strength Level
o Maximum (Peak) Signal Strength Level
o Number of False Alarms
o Average False Alarms
o Maximum (Peak) False Alarms.
3. Compatibility and Interoperability
•
Normal functionality of the unit is disabled when running from this version.
•
BreezeCONFIG ACCESS does not support units running the Spectrum Sweep firmware. The
message "Invalid response from host" will appear upon unit selection. For remote
management use telnet instead.
•
BreezeACCESS XL products operating in FDD (Frequency Division Duplex) mode are not
supported by this firmware.
•
Remote Management and configuration can be performed only behind the Ethernet port of the
device as normal radio functionality is disabled.
•
Subscriber Units with Voice port are not supported.
•
The Firmware version is supported by BreezeACCESS Spectrum Analyzer Utility version
1.2.2.
Alvarion Inc.
BreezeCOM and Floware unite
page 2 of 3