3M Digital Projector WX66 Manual de Segurança do Produto - Página 6
Procurar online ou descarregar pdf Manual de Segurança do Produto para Projetor 3M Digital Projector WX66. 3M Digital Projector WX66 17 páginas. Setup guide
Também para 3M Digital Projector WX66: Manual de configuração (1 páginas), Manual de início rápido (1 páginas), Ficha de especificações (2 páginas)
Imprimir página
•
To reduce the risk associated with choking:
-
Keep the battery away from children and pets.
•
To reduce the risk associated with exposure to hazardous voltage:
-
Disconnect power cord when the projector is not in use, during lamp
replacement, and while cleaning.
-
Do not remove any screws other than those specified in the lamp replacement
instructions.
-
Do not store or operate this projector in wet environments.
-
Do not modify this projector.
-
Do not attempt to service the projector - there are no user serviceable parts,
other than the lamp cartridge, inside the projector. Contact a 3M authorized
service provider for service.
-
Do not allow water or other liquids to enter the projector.
•
To reduce the risk associated with environmental contamination due to
mercury in the projection lamp:
-
Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.
-
The lamp in this product contains mercury. Dispose of projection lamp in a manner
that is consistent with your local hazardous waste regulations for mercury.
-
For recycling and disposal information, contact your respective governmental
agencies.
In U.S., contact 1-800-328-1371 (3M US) or the Electronic Industries Alliance at
www.lamprecycle.org
In Canada, contact 1-800-364-3577 (3M Canada)
•
To reduce the risk associated with exposure to hazardous voltage and/or fire:
-
Replace power cord if damaged.
-
Contact a 3M authorized service provider if the projector becomes damaged.
-
Use a grounded extension cord with a rating at least equal to that of the projector.
-
Connect this projector to a grounded outlet.
•
To reduce the risk associated with hazardous voltage, impact, tripping, and
intense visible light:
-
Do not use this projector around unsupervised children.
•
To reduce the risk associated with hot surface of lamp cartridge:
-
Unplug the projector from the electrical outlet and allow the lamp to cool for 45
minutes before replacing the lamp.
•
To reduce the risk associated with a ruptured lamp:
-
Always handle the fragile lamp module with care.
-
Remove the projector from the ceiling or wall mount before replacing the lamp.
-
Use care when replacing the lamp module in the event of a lamp rupture - small
glass particles and small amounts of mercury may be present.
-
Ventilate the area where the lamp rupture occurred.
-
Wear safety goggles and gloves when cleaning up ruptured lamp debris.
-
Carefully collect the ruptured lamp debris in a closed container and dispose of
the container and the expired lamp module in accordance with federal, state,
and local regulations.
-
Wash your hands thoroughly after handling ruptured lamp debris.
-
Replace the lamp module when the lamp replacement message appears.
-
Never replace the lamp module with a previously used lamp module.
6
WARNING
3M™ Digital Projector WX66 Product Safety Guide
© 3M 2008. All rights reserved.