AKO 55724 Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Sistema de segurança AKO 55724. AKO 55724 16 páginas. Gas leak detection alarm

6.- Configuration

Alarm Station

AKO-55624

No configuration needed

AKO-55724

The

input auto-detection

It is only necessary to follow these steps:

Step 1

When receiving a power supply for the first time, the alarm enters

INPUT AUTO-DETECTION MODE, lighting up the input indicators

sequentially in green.

Step 2

Select the 2 or 4 area operation mode using the Mute push-button.

Step 3

Begin AUTO-DETECTION by pushing the 'AUTOCONFIG' push-button

for 5 seconds (See page 4). At the end of the process, the alarm will

emit 5 short beeps and will begin to function normally.

For correct input detection, all devices must be correctly

connected and in NO ALARM mode, including the push-

buttons connected in digital inputs.

Once the alarm has been configured, this function will not be activated again. To activate it again,

disconnect the power supply, connect it again and press the "AUTOCONFIG" pushbutton 5 times

consecutively within 2 minutes and repeat step 2 within another 2 minutes.

All Models

Self-diagnosis function

The device incorporates a self-diagnosis system which informs the user in the event of a transmitter / detector

malfunction or if there are wiring errors.

If a malfunction is detected, the alarm will emit 3 short beeps every 2 minutes and the corresponding input

indicator will flash red.

Pre-alarm jumper

It allows deactivating pre-alarm detection (See page 4). Before using

this option, make sure that regulations allow for only one alarm

level.

Pre-alarm enabled

When using the ammoniac or CO2 transmitter / detector, the pre-alarm must be enabled.

function facilitates station configuration.

Pre-alarm disabled

OFF

5572H402 Ed.03