Replacing Lamp
The glass lamp used in this projector contains small amounts of mercury and operates at
high pressure and at high temperature and may unexpectedly shatter. Each lamp has a
different lifetime and can fail in different ways, including a rupture with a loud bang or
simply burn out. In the event of a lamp rupture, be sure to follow the instructions.
•
To reduce the risk associated with exposure to hazardous voltage:
-
Disconnect power cord when the projector is not in use, during lamp replacement,
and while cleaning.
-
-
Do not attempt to service the projector - there are no user serviceable parts, other
than the lamp cartridge, inside the projector. Contact a 3M authorized service
provider for service.
•
To reduce the risk associated with hot surface of lamp cartridge:
-
Unplug the projector from the electrical outlet and allow the lamp to cool for 45
minutes before replacing the lamp.
•
To reduce the risk associated with a ruptured lamp:
-
Always handle the fragile lamp module with care.
-
Remove the projector from the ceiling or wall mount before replacing the lamp. In
the case of a lamp rupture, small glass particles could fall out when the lamp door
is opened or the projector is tilted.
-
Use care when replacing the lamp module in the event of a lamp rupture - small
glass particles and small amounts of mercury may be present.
-
Ventilate the area where the lamp rupture occurred.
-
Wear safety goggles and gloves when cleaning up ruptured lamp debris.
-
Carefully collect the ruptured lamp debris in a closed container and dispose of the container
and the expired lamp module in accordance with federal, state, and local regulations.
-
Wash your hands thoroughly after handling ruptured lamp debris.
-
Replace the lamp module when the lamp replacement message appears.
-
Never replace the lamp module with a previously used lamp module.
•
To reduce the risk associated with environmental contamination due to mercury:
-
Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.
•
To reduce the risk associated with explosion, and/or chemicals from a leaking battery:
-
Use only with battery type AA or equivalent.
-
Orient the battery's plus (+) and minus (-) terminals of the batteries according to
the markings found on the remote control.
-
Do not leave the battery in the remote for an extended period of time.
-
Do not carry batteries loose in your pocket or purse.
-
Avoid eye and skin contact in the event that battery would leak.
-
Do not mix used and new batteries.
•
To reduce the risk associated with intense visible light:
-
Avoid looking directly into the projector lens while the lamp is on.
Important Note:
elsewhere besides the lamp. If this happens, contact your local dealer or a service representative.
© 3M 2006
WARNING
CAUTION
3M™ Multimedia Projector S15i Product Safety Guide
11
Imprimir página