Blue Clean BC383HSS Instruções de montagem, cuidados e utilização - Página 14

Procurar online ou descarregar pdf Instruções de montagem, cuidados e utilização para Máquina de lavar roupa de pressão Blue Clean BC383HSS. Blue Clean BC383HSS 18 páginas. 2150 psi electric pressure washer

Imprimir página

OPERATING INSTRUCTIONS

CARE AND MAINTENANCE

Detergents

• Use detergents designed for power washers. These

can be purchased online at our website www.

arblueclean.com. Hardware stores or home centers

also have power washer detergents for different

cleaning projects. The cleaning solution should be

the consistency of water in order to prevent clogging

your detergent bottle and nozzle.

• This system applies detergent under low pressure.

The cleaning power of the detergents is enhanced

when applied with low pressure and enough time is

given to break down dirt and grime. The combination

of low pressure and chemical action is very effective

and can be better than scrubbing if applied properly.

ALWAYS spray detergent on a dry surface. DO NOT

the detergent and reduces its cleaning ability. DO

NOT allow detergent to dry on surface. On vertical

surfaces being cleaned, apply detergent to lower

surfaces and work your way up to prevent detergent

from causing streaks in the dirt and grime. Rinse

detergent by pressure washing from bottom up for

same reason.

• If a stain is particularly tough, it may be necessary

to reapply the detergent and use a bristled brush to

scrub the stain. Subsequent power washing after

brushing should successfully complete your cleaning

job.

Cleaning Garden Hose Adapter

• The screen inside the adapter should be cleaned

periodically. Remove it by dragging a thumb over the

screen with enough pressure to pull the screen and

washer out. Rinse it with clean water and then place it

back in the adapter.

Cleaning Nozzles

• A clogged or partially clogged nozzle can cause

of the nozzle and/or cause the unit to pulsate while

spraying.

• Turn off the unit.

• Turn off the water supply to the unit.

• Relieve any pressure trapped in the hose by

squeezing the trigger 2-3 times, and then lock the

spray gun.

• Using the nozzle tip cleaner provided (or an unfolded

paper clip), insert the wire into the nozzle hole and

move back and forth until debris is dislodged.

hose and highest pressure available (either standard

water nozzle or use your thumb over the nozzle to