Dobinsons BU59-3707 Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para Acessórios para automóveis Dobinsons BU59-3707. Dobinsons BU59-3707 10 páginas. Bullbar for toyota hilux revo 2015 on

Imprimir página

23. Now a good time to run the wiring for the

new parker lights and indicators.

24. In the base of the headlight you will see a light

grey and dark grey wire connector this will

slide out from the headlight and the plug can t

then be disconnected.

25. It is recommended to take the earth directly

off the vehicle body.

26. For the parker light positive feed it can be

taken from the vehicle side of the wiring loom

(the light grey plug) and taken from the grey

wire on the right hand side and green wire on

the left hand side (Australian vehicles) NOTE:

you must double check this with a multimeter

or test light to confirm.

27. For the indicator positive feed, there is a small

conduit that goes up into the back of the

indicator, this can be pulled down below the

headlight and the red wire on the right hand

side used, and the yellow on the left hand side

(Australian vehicles) NOTE: you must double

Dobinsons Springs and Suspension

check this with a multimeter or test light to

confirm.

28. Using the diagram at the end of this manual,

join the corresponding wires to original

vehicle wires located in the previous step. The

wires can be joined by either using good

quality snap lock crimp connectors or by

soldering (soldering recommend. Ensure the

connection is secure and is sufficiently

insulated.

29. If fitting a bullbar with fog lights, the fog lights

can be connected using the original vehicle

fog light wires if fitted but this will require

cutting and joining the fog light plugs from the

loom supplied. If the vehicle is not fitted with

OEM fog lights the wiring loom supplied can

be used. Follow the wiring diagram at the end

of this manual.

30. Carefully un-wrap the bulbar taking care not

to scratch it especially on the top loops.

Reinstall the number plate. If installing driving

lights to the bullbar it is easiest to install now.

31. If not installing a winch skip to step 39.

32. See the Installation section of your Dobinsons

4x4 Winch manual for specific detailed fitting

instructions. For a brief overview see the

following steps.