Et BLUE-ROLL Manual de instalação - Página 14
Procurar online ou descarregar pdf Manual de instalação para Abertura de porta de garagem Et BLUE-ROLL. Et BLUE-ROLL 17 páginas. Domestic type roll-up garage door operator
Imprimir página8.3 Slightly re-tighten the two wing-nuts
8.4 Power controller up by connecting the mains power first and then the battery leads
8.5 Pull the manual release handle to change the opener back to automatic mode.
Testing and adjusting travel limit settings (RIGHT-HAND fit):
8.6 Close position:
Press and release the onboard test button. If the door does not stop at the pre-set closed position, repeat step 6.3
above. Turn the closed limit cam anti-clockwise to raise the closed position or clockwise to lower it. Tighten the
wing-nuts after the adjustment
8.7 Open position:
Press and release the onboard test button. If the door does not stop at the pre-set open position, repeat step 6.2
above. Turn the open limit cam anti-clockwise to raise the open position or clockwise to lower it. Tighten the wing-
nuts after the adjustment.
B: LEFT-HAND SIDE INSTALLATION.
Remove the back cover from the opener using a screwdriver. Pull the manual release handle to change opener to the
manual operation mode.
9.1 Open Limit:
Raise the door manually to the open position you would like it to stop at. Slightly loosen the wing-nuts that lock
the cam (to the extent that you can rotate the cam by hand while the cam can not rotate itself). Rotate the
open limit cam (inner cam) anti-clockwise by hand in the direction of the limit switch until the cam clicks the
open limit switch (see Fig. 16).
9.2 Closed Limit:
Close the door manually to a closed position so that the bottom edge of the door just touches the floor. Rotate
the closed limit cam (outer cam) by hand clockwise until the cam clicks the closed limit switch (see Fig. 16).
9.3 Slightly re-tighten the two wing-nuts
9.4 Power controller up by connecting the mains power first and then the battery leads
9.5 Pull the manual release handle to change the opener back to automatic mode.
Testing and adjusting travel limit settings (LEFT-HAND fit):
9.6 Close position:
Press and release the onboard test button. If the door does not stop at the pre-set closed position, repeat step 6.3
above. Turn the closed limit cam anti-clockwise to raise the closed position or clockwise to lower it. Tighten the
wing-nuts after the adjustment
9.7 Open position:
Press and release the onboard test button. If the door does not stop at the pre-set open position, repeat step 6.2
above. Turn the open limit cam anti-clockwise to raise the open position or clockwise to lower it. Tighten the wing-
nuts after the adjustment.
IMPORTANT NOTE: If the door stops on the down cycle and reverses on the up cycle, when encountering an
obstruction/binding, then the motor wires are connected incorrectly and must be reversed
14