ET&F 610 Manual de instruções e instruções de segurança - Página 12

Procurar online ou descarregar pdf Manual de instruções e instruções de segurança para Pistola de pregos ET&F 610. ET&F 610 20 páginas.

Imprimir página

Label showing the pitch of pins

NOTE: Care is advised in the following cases since the

nail guide may not close or pins may not feed

properly:

• Pins and collating sheet are not inserted to the

prescribed position

• Pins rise off of the guide surface

• Collating wire of the pins or the like is deformed

• Changeover lever position is not set according to

the collating system of the pins

(8) Lock the knob completely.

NAILER OPERATION

Read section titled "SAFETY"(pages 3 – 5).

DANGER

Always wear eye protector which conforms to

ANSI Z87.1 specifications.

WARNING

Never point Nailer toward yourself or anyone else.

Never carry with finger on trigger.

Remove finger from trigger when not driving pins.

Never place your hands or feet closer than 8 inches

(200 mm) from firing head when using.

Do not drive pins on top of other pins or with

Nailer at too steep of an angle; pins can ricochet

and hurt someone.

In order to avoid double fire or unwanted ejection

of a nail due to bouncing of the Nailer.

1) do not push Nailer on workpiece with strong

force;

2) take Nailer away from workpiece using recoil;

3) release trigger quickly when performing trigger

fire.

Do not drive pins near corners and edges of

workpiece. Pins can be driven through or away

from workpiece and hit someone.

Never drive pins from both sides of a wall at the

same time. Pins can be driven into and through the

wall and hit a person on the opposite side.

Never use Nailer which is defective or operating

abnormally.

Do not use Nailer as hammer.

Disconnect air hose from Nailer when:

1) it is not in use;

2) leaving work area;

3) moving it to another location; and

4) handing it to another person.

This nailer has a SEQUENTIAL TRIP MECHANISM.

METHOD OF OPERATION

This Nailer is equipped with the push lever and does not

operate unless the push lever is depressed (upward

position).

To drive pins with this nailer:

1 Position the outlet on the workpiece with finger off the

trigger.

2 Depress the push lever firmly until it is completely

depressed.

3 Pull the trigger to drive a pin.

4 Remove finger from the trigger.

To drive another pin, move the Nailer along the

workpiece and repeat this procedure.

Keep your finger off the trigger except during

fastening operation, because serious injury could

result if the push lever accidentally contacts you or

others in work area.

Keep hands and body away from the discharge

area. The nailer with contact trip mechanism may

bounce from the recoil of driving a fastener and

unwanted subsequent fastener may be driven,

possibly causing injury.

Some types of loaded pins can spark out of the

muzzle during a pin driving operation. Exericise

caution!

THE SEQUENTIAL TRIP MECHANISM (SINGLE SHOT

PARTS) is for use where precision fastener placement is

desired and must be operated in accordance with the

following "Method of Operation".

You must first depress the push lever (upward posi-

tion) where you want to drive a pin and then pull the

trigger. After the each pin is driven, completely release

the trigger and lift the tool off the work surface. The

SEQUENTIAL TRIP MECHANISM may reduce the

— 12 —

Trigger

WARNING