Fleck 3200ET Manual de serviço - Página 8

Procurar online ou descarregar pdf Manual de serviço para Unidade de controlo Fleck 3200ET. Fleck 3200ET 12 páginas. Remote meter

3200ET Remote Meter

Control Operation (Cont'd.)

Operation During Programming

The control will only enter the Program Mode with the timer in Service and operating on line power. While in the

Program Mode the control will continue to operate normally monitoring water usage and keeping all displays up to date.

Control programming is stored in memory permanently with or without line or battery backup power.

Lockout Input Operation

The Lockout Arrow will turn on whenever a Lockout Signal is being received by the control. Any requests for

regeneration will be delayed until this signal is removed. Regeneration will then proceed normally.

Keypad Operation

Extra Cycle Button -

Pushing this button will initiate a regeneration cycle independently of actual timer conditions.

1. With immediate regeneration timers this extra regeneration would occur immediately.

2. With delayed regeneration timers this extra regeneration would occur at the set Regeneration Time. A regeneration

cycle can be forced to occur immediately by pushing and holding in for 5 seconds this button.

Totalizer/Flow Rate Button -

This button is used to view the Totalizer and Flow Rate Displays. Depressing the button once will display flow rate.

Depressing the button again will display the total accumulation of water flow through the meter since it was last reset.

Depressing the button once more will return the display to Time Of Day or Volume Remaining.

The Totalizer display is reset by depressing and holding this button for 25 seconds. During the 25 seconds, the Totalizer

Arrow will flash as an indicator to the operator that the display is being reset properly.

Program Button -

This button is used by the installer to program those settings indicated on the front panel by red LEDs.

Up Set Button -

This button is used to set the current time of day, adjust time remaining in a regeneration cycle step, and in timer

programming. The Up Arrow Button will increment a display setting.

Down Set Button -

This button is used to set the current time of day, adjust time remaining in a regeneration cycle step, and in timer

programming. The Down Arrow Button will decrement a display setting.

Low Battery Indicator

When the control is operating on line power this red LED will turn on whenever the 9V alkaline battery (Not Included)

used for memory backup needs to be replaced. The battery is stored against the timer backplate. In the event of a

power outage, the battery will maintain current operating displays for approximately 24 hours at maximum battery

capacity.

Page 8

Low Battery

Printed in U.S.A.