Etabeta electronics JNR 90L BEAM G Manual - Página 6

Procurar online ou descarregar pdf Manual para Equipamento de iluminação Etabeta electronics JNR 90L BEAM G. Etabeta electronics JNR 90L BEAM G 7 páginas. Junior

Imprimir página

OPERATION INSTRUCTIONS

· The JNR 90L BEAM G is for beam effect for on-site decoration purpose.

· Don't turn on the fixture if it's been through severe temperature difference like

after transportation because it might damage the light due to the environment

changes. So make sure to operate the fixture until it is in normal temperature.

· This light should be keep away from strong shaking during any transportation or

movement.

· Don't pull up the light by only the head, or it might cause damages to the

mechanical parts.

· Don't expose the fixture in overheat, moisture or environment with too much dust

when installing it. And don't lay any power cables on the floor. Or it might cause

electronic shock to the people.

· Make sure the installation place is in good safety condition before installing the

fixture.

· Make sure to put the safety chain and check whether the screws are screwed

properly when installing the fixture.

· Make sure the lens are in good condition. It's recommended to replace the units if

there are any damages or severe scratch.

· Make sure the fixture is operated by qualified personnel who knows the fixture

before using.

· Keep the original packages if any second shipment is needed.

· Don't try to change the fixtures without any instruction by the manufacturer or

the appointed repairing agencies.

· It is not in warranty range if there are any malfunctions from not following the

user manual to operate or any illegal operation, like shock short circuit, electronic

shock, lamp broke, etc.

INSTALLATIONS

Cautions: For added protection mount the fixtures in areas outside walking paths,

seating areas, or in areas were the fixture might be reached by unauthorized personnel.

Before mounting the fixture to any surface, make sure that the installation area can

hold a minimum point load of 10 times the device's weight.

Fixture installation must always be secured with a secondary safety attachment, such

as an appropriate safety cable.

.05.

Never stand directly below the device when mounting, removing, or servicing the

fixture.

from a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture

is kept at least 0.5m (1.5 ft) away from any flammable materials (decoration etc.).

Always use and install the supplied safety cable as a safety measure to prevent

accidental damage and/or injury in the event the clamp fails.

Mounting points: Overhead mounting requires extensive experience, including

amongst others calculating working load limits, a fine knowledge of the installation

material being used, and periodic safety inspection of all installation material and the

fixture. If you lack these qualifications, do not attempt the installation yourself.

Improper installation can result in bodily injury.

Be sure to complete all rigging and installation procedures before connecting the

main power cord to the appropriate wall outlet.

Clamp mounting: The JNR 90L BEAM G provides a unique mounting bracket

assembly that integrates the bottom of the base, and the safety cable rigging point in

one unit (see the illustration below). When mounting this fixture to truss be sure to

secure an appropriately rated clamp to the included omega bracket using a M10 screw

fitted through the center hole of the "Hanging Kit". As an added safety measure be

sure to attached at least one properly rated safety cable to the fixture using on of the

safety cable rigging point integrated in the base assembly .

②

① Omega Clamp

② Satety Clamp

③ Safety Cable

④ Screw

③

①

④

1/4 Turn

.06.