Etable E1203 Manual de Segurança e Operação - Página 3

Procurar online ou descarregar pdf Manual de Segurança e Operação para Arrancador remoto Etable E1203. Etable E1203 7 páginas. Jump starter power bank

Imprimir página

Operation

LED torch

• Hold down the power switch (5) for 3 seconds to turn on the torch.

• Four modes of LED light (3) can be navigated through by lightly pressing on

the power button (Normal, SOS, Strobe and Off).

Charging mobile devices

• Plug the mobile phone/tablets charging cable into one of the two USB ports (2)

• Once the charging device has been connected to the correct USB port, press the

power switch (5) and your device will start charging.

• Plug the switch cable to 12V/10A;19V/3.5A output ports(7), connect to your laptop

and other 12V automotive electrical appliances with appropriate connectors, press

the power switch (5) and your device will start charging.(Turn off laptop when use

the product charge it)

Charging the jump starter

1. Plug the mains power adapter into a suitable power supply.

2. Connect the adapter to the power bank input port (4).

1. Plug the car adapter into a 12V power supply.

2. Connect the car adapter to the power bank input port (4).

1. Plug the USB cable into a 5V Power supply

2. Connect the USB cable to the power bank input port (4)

• The charging time for this product is approximately 5.6 hours to reach full charge

from flat.

Battery indicator

• Press the power switch (5)

• The battery indicator (1) will show the battery status of the product. (1 solid for 25%;

2 solids for 50%;3 solids for 75%; 4 solids for 100%)

• The jump starter indicator(8) turns red when the unit has enough power to start

vehicles, turns off when low power

Jump starting vehicle

Make sure the power bank has greater power to ensure correct function.

1.Plug the cord of the jump lead into the 12V output port (6)

2. Connect the red jump lead battery clamp to the vehicles positive battery terminal

(+,red in color) and the black battery clamp to the vehicles negative (-, black in color)

battery terminal.

3. Start the vehicle.

4. Once the vehicle has been started, disconnect the red & black jump lead clamps