DOD SR 834 Manual do Proprietário - Página 2

Procurar online ou descarregar pdf Manual do Proprietário para Crossover DOD SR 834. DOD SR 834 10 páginas. Sr series

Imprimir página

These symbols are internationally accepted symbols that warn of potential

hazards with electrical products.The lightning flash means that there are

dangerous voltages present within the unit.The exclamation point indicates

that it is necessary for the user to refer to the owners manual.

These symbols warn that there are no user serviceable parts inside the unit.

Do not open the unit. Do not attempt to service the unit yourself. Refer all

servicing to qualified personnel. Opening the chassis for any reason will void

the manufacturer's warranty. Do not get the unit wet. If liquid is spilled on

the unit, shut it off immediately and take it to a dealer for service.

Disconnect the unit during storms to prevent damage

U.K. Mains Plug Warning

A molded mains plug that has been cut off from the cord is unsafe.

Discard the mains plug at a suitable facility. Never under any circum-

stances should you insert a damaged or cut mains plug into a 13

amp power socket. Do not use the mains plug without the fuse cover

in place. Replacement fuse covers can be obtained from your local retail-

er. Replacement fuses are 13 amps and MUST be ASTA approved to

BS1362.

Safety Instructions

Notice for customers if your unit is equipped with a power cord.

Warning:This appliance must be earthed.

The cores in the mains lead are colored in accordance with the following

code:

Green and Yellow - Earth Blue - Neutral

As colors of the cores in the mains lead of this appliance may not corre-

spond with the colored markings identifying the terminals in your plug, pro-

ceed as follows:

•The core which is colored green and yellow must be connected to the

terminal in the plug marked with the letter E, or with the earth sym-

bol, or colored green, or green and yellow.

•The core which is colored blue must be connected to the terminal

marked N, or colored black.

•The core which is colored brown must be connected to the terminal

marked L, or colored red.

This equipment may require the use of a different line cord, attachment

plug, or both, depending on the available power source at installation. If the

attachment plug needs to be changed, refer servicing to qualified service

personnel who should refer to the table below.The green/yellow wire shall

be connected directly to the unit's chassis.

CONDUCTOR

LIVE

NEUTRAL

EARTH GND

Warning: If the ground plug is defeated, certain fault conditions in the unit

or in the system to which it is connected can result in full line voltage

between chassis and earth ground. Severe injury or death can then result if

the chassis and earth ground are touched simultaneously.

Brown - Live

WIRE COLOR

Normal

Alt

BROWN

BLACK

BLUE

WHITE

GREEN/YEL

GREEN

Warning

For your protection, please read the following:

Water and Moisture: Appliances should not be used near water

(e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet

basement, or near a swimming pool, etc.) Care should be taken so

that objects do not fall and liquids are not spilled into the enclosure

through openings.

Power Sources: The appliance should be connected to a power

supply only of the type described in the operating instructions or as

marked on the appliance.

Grounding or Polarization: Precautions should be taken so that

the grounding or polarization means of an appliance is not defeated.

Power Cord Protection: Power supply cords should be routed so

that they are not likely to be walked on or pinched by items placed

upon or against them, paying particular attention to cords at plugs,

convenience receptacles, and the point where they exit from the

appliance.

Servicing: To reduce the risk of fire or electrical shock, the user

should not attempt to service the appliance beyond that described in

the operating instructions. All other servicing should be referred to

qualified service personnel.

For units equipped with externally accessible fuse recepta-

cle: Replace fuse with same type and rating only.

Electromagnetic Compatibility

Operation is subject to the following conditions:

•This device may not cause harmful interference.

•This device must accept any interference received, including

interference that may cause undesired operation.

•Use only shielded interconnecting cables.

•Operation of this unit within significant electromagnetic fields

should be avoided.