Cane DRX Range Extender Kit Manual de instalação

Procurar online ou descarregar pdf Manual de instalação para Extensor Cane DRX Range Extender Kit. Cane DRX Range Extender Kit 4 páginas.

The DTR Range Extender (DRX) kit uses two Motorola DTR™ Series digital radios to receive (RX) and retransmit (TX)

a single public or private group. Additional DTR repeater kits are required to repeat each additional public or private

group.

CAUTION! The radios used in the DRX kit contains special programming and settings to allow it to operate as a

repeater. Do NOT replace the radios in the DRX RX and TX units with standard DTR radios!

Note: The DTR Range Extender kit will only repeat ONE Public or Private group (Private contacts will NOT be

repeated but can still connect directly from radio to radio). Additional DRX kits will be needed to extend coverage

coverage or to repeat additional groups.

GETTING STARTED

Your unit contains LiION batteries that need to be charged before use. These batteries power the units and allow for

approximately10 hrs of battery back-up in the event of a power outage. If the batteries are depleted they will need to

be recharged or replaced and the units reset to resume operation.

Installing and charging the battery (skip steps 1 to 3 if battery is already installed)

1. Remove the back cover of the DTR repeater kits by unscrewing the four self tapping screws.

2. Remove the battery door cover from the radio in the Repeater kit (remember to unlock the latch on the battery

door).

3. Insert the included LiION battery into the battery compartment of the radio in the DTR Repeater kit.

4. Plug the power supply into the Power/programming port and the A/C connector to the wall outlet to begin

charging the unit (Green LED will turn on). Charge the unit for at least 3hrs before using.

NOTE: The LiION batteries should be replaced every two years for optimal performance.

PROGRAMMING

Note: The DTR Range Extender kits are default programmed to operate on Public 5 (Channel 1; Group 5). You do not

need to program the DTR repeater kits if your portable units are also set to use the default Public 5 Group.

The DRX kit can be programmed using the standard DTR radio Computer Programming Software (CPS) available from

Motorola at http://www.motorolasolutions.com

Note: You will need a DTR programming cable p/n 0105950U15 to connect the unit to your computer for

programming.

The following instructions assume you already have a working knowledge of using the DTR CPS tool. To learn more

about using the DTR CPS tool please read the help file from the CPS menu or instructions from the DTR radio user

manual.

Version 1.4

DRX Range Extender Kit Installation Guide

www.canewirelesspro.com

Page 1