Canford TECPRO 2 BP511 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Sistema de intercomunicação Canford TECPRO 2 BP511. Canford TECPRO 2 BP511 7 páginas. Dual circuit beltpack with vibration alert
Imprimir páginaMISCELLANEOUS
Circuit Enable/Disable
BP523 and BP543
If only one circuit is connected, then only this circuit is active. On the unused circuit, the line amplifier is dis-
abled and the Mic LED does not light if the Mic key is pressed.
BP525 and BP545
With XLR-5 connectors, a given circuit is only active if its +24 volt line is powered.
Mic Disable
If no headset is connected, the Mic functions will be disabled.This will prevent immediate feedback if the
headset is re-connected with the volume control on maximum but the headset not being worn.
TECHNICAL SPECIFICATION
Power requirements:
Supply voltage:
Max current consumption:
With vibrate selected:
Headphone output:
Microphone input:
Connectors:
Case material:
Dimensions:
Weight without vibration motor:
Weight with vibration motor:
WIRING CONVENTIONS
System cable connectors:
XLR 3 pin
BP511
Pin 1 Earth/screen
Pin 2 +24V DC
Pin 3 Audio
XLR 5 pin
BP523 and BP525
Pin 1 Earth/screen/0V
Pin 2 +24V DC
Pin 3 Audio, Circuit I
Pin 4 +24V DC
Pin 5 Audio Circuit II
Headset connectors:
XLR 4 pin
Pin 1 Microphone Earth/screen
Pin 2 Microphone signal
Pin 3 Earphones Earth/screen
Pin 4 Earphones signal
24 - 30 volts DC
40 mA in "Call" mode (all LEDs on)
50mA
8 ohm to 4Kohm headphones
200 to 600 ohm dynamic microphones
BP511 XLR 3 pin male and female - loop through
BP523 XLR 3 pin female, circuit I, circuit II
BP525 XLR 5 pin male and female - loop through
Headset - XLR 4 pin male
High impact ABS
120mm (L) x 103mm (W) x 54mm (H)
240g
260g
Page 3