Acqua GY-NE272TM Manual de instruções - Página 13
Procurar online ou descarregar pdf Manual de instruções para Frigorífico Acqua GY-NE272TM. Acqua GY-NE272TM 15 páginas.
1 3
Thoroughly dry all surfaces and
removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior
walls if the freezer door is opened
frequently or kept open too long. If the
frost is too thick, choose a time when
the supply of food stocks are low and
proceed as follows:
1 . R e m o v e e x i s t i n g f o o d a n d
accessories baskets, unplug the
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
thawing process.
2. When defrosting is completed, clean
your freezer as described above.
Caution! Don't use sharp objects to
remove frost from the freezer
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back
into the mains socket.
Troubleshooting
If you experience a problem with your appliance or are concerned that the appliance
If you experience a problem with your appliance or are concerned that the
is not functioning correctly, you can carry out some easy checks before calling for
appliance is not functioning correctly, you can carry out some easy checks before
service, please see below.
calling for service, please see below. You can carry out some easy checks
Warning! Don't try to repair the appliance yourself. If the problem persists after you
according to this section before calling for service.
have made the checks mentioned below, contact a qualified electrician, authorized
Warning! Don't try to repair the appliance yourself. If the problem persists after you
service engineer or the shop where you purchased the product.
have made the checks mentioned below, contact a qualified electrician, authorized
service engineer or the shop where you purchased the product.
Hisense Refrigerator
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution!
Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged, contact the customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4. Replace LED light and snap it
correctly in place.