DOEPFER Dark link Manual do Proprietário - Página 12

Procurar online ou descarregar pdf Manual do Proprietário para Equipamento de gravação DOEPFER Dark link. DOEPFER Dark link 20 páginas. Usb/midi-to-cv/gate interface
Também para DOEPFER Dark link: Manual do Proprietário (20 páginas)

Imprimir página

DOEPFER

For setting these parameters, MIDI Program Change messages coming from your MIDI device are used.

Normally, you will have to press the program change keys on your MIDI keyboard or MIDI synthesizer while

in „learn" mode. Bear in mind that some manufacturers count the MIDI program change numbers from 0 to

127 rather than from 1 to 128 as defined by the MIDI standard. If the lowest program change number you

can send with your MIDI device is 0 (zero), you have to subtract 1 from the program change numbers in the

table above because in this case the program changes of your device range from 0 to 127 instead of 1 to

128. For some devices (especially software sequencers) the type of program change numbering

can be selected. In this case you should use the 1 to 128 range to comply with the numbers in the table

above.

The program change messages must be sent on Dark Link's MIDI channel (please refer to section „MIDI

channel selection / learn button" on page 9).

(2) Velocity on/off

These program-change messages are used to select whether the note-on velocity affects the control volta-

ges CV3 and / or CV4. If velocity is „off", only volume (CV3) respectively the unassigned controller (CV4) is

used to generate the control voltage. If velocity is „on", the volume or controller value is multiplied with the

note-on velocity, i.e. the CV value changes with every new note event as the velocity of the note event is

used to calculate the control voltage together the volume message (CV3) resp. the unassigned controller

(CV4).

(3) Retrigger on/off

With this parameter you can select whether a new gate/trigger pulse is generated when playing legato (i.e.

playing a new key on the keyboard without releasing the key played previously). The factory default setting

is „retrigger off". Additionally, the MIDI controllers legato (controller #68) and sustain (controller #64) affect

the gate output in the usual way.

(4) Trigger polarity

With this function you may select between not inverted/normal trigger (meaning +5V/+U when key is

pressed and 0V when no key is pressed) and inverted trigger (meaning 0V when key is pressed and

+5V/+U when no key is pressed).

When using a switch trigger cable (needed for some vintage Moog and Korg synthesizers) the situation is

exactly vice versa.

If your synthesizer might behave in a reversed way (envelopes are started when key is released instead of

being pressed) please simply change the trigger polarity.

(6) CV1 Key Assign Mode (Note Priority)

These program change messages adjust the type of assign modes for CV1.

• If „highest note" is selected, the highest key pressed on the MIDI keyboard is used to calculate CV1 if

more than one key is being held.

• In the „last note mode" always the last note played (chronologically) is taken as CV1. „Reference note"

means that only the reference note is accepted. This feature is useful if you want to trigger different

devices from the same MIDI channel using two or more Dark Link's. In this case you have to set the

reference keys for each Dark Link unit to a different value.

Dark link

Functions