ClipperCreek HCS SERIES Manual de instalação - Página 7
Procurar online ou descarregar pdf Manual de instalação para Carregador de bateria ClipperCreek HCS SERIES. ClipperCreek HCS SERIES 9 páginas. Quad-mount kit.
innovative infrastructure for
electric and hybrid vehicles
Também para ClipperCreek HCS SERIES: Manual de instalação (20 páginas)
Imprimir página7. Install the Charger Mounting Plate
A charger mounting plate is affixed to the front of
the pedestal post to provide a flat and rigid base on
which the charger can be mounted. In the case of a
Dual-Mount installation, a second mounting plate is
affixed to the opposite side of the pedestal post.
Hold the charger mounting plate against the front
•
side of the pedestal post as shown in Figure 11.
Align the center screw hole of the mounting plate
•
with the corresponding top threaded insert on the
front of the pedestal post.
Secure the mounting plate to the pedestal with one
•
(1) 1/4-20 x 3/4" Torx flat-head tapered screw
using a T27 Torx driver. Tighten until the head of
the screw is flush with the surface of the mounting
plate.
For Dual-Mount Charger Installations:
The Dual-Mount Kit includes a second charger
•
mounting plate. This second mounting plate is
affixed to the back side of the pedestal post,
opposite of the first mounting plate.
As with the first mounting plate, align the center
•
screw hole of the mounting plate with the
corresponding top threaded insert on the front of the
pedestal post and tighten one (1) 1/4-20 x 3/4" Torx
flat-head tapered screw using a T27 Torx driver
until the screw head is flush with the surface of the
mounting plate.
Figure 11: The Charger Mounting Plate
HCS Series EVSE Pedestal Installation Guide
8. Mounting a Single Charger to the Pedestal
With the mounting plate in place, the pedestal is now
ready for a single charger to be mounted.
Place a 1/4" Neoprene-bonded sealing washer around the
•
shaft of each of the two (2) 1/4-20 x 2" Torx button-
head screws. The metal portion of the washer should
face the head of the screw while the neoprene should
face the tip of the screw.
There are two different styles of HCS plastic angle
•
washers. The correct style to use with the HCS Pedestal
is the Perpendicular Screw Mount. These washers are
included with the HCS Charging Station and do not
accompany this kit. Refer to Figure 12.
Align the two screw holes on the top and bottom of the
•
charger with the corresponding threaded inserts on the
mounting plate.
Use a T27 Torx driver to secure the top of the charger
•
first using one (1) 1/4-20 x 2" Torx button-head screws
with neoprene washer and HCS Plastic Angle Washer
as shown in Figure 13. Do not over-tighten.
Page 7 of 9
Figure 12: HCS Plastic Angle Washers
Figure 13: Mounting a Single HCS Charger:
Install Top screw FIRST