Dog Care WELL-D ADV TC01 Manual de início rápido

Procurar online ou descarregar pdf Manual de início rápido para Produtos para animais de estimação Dog Care WELL-D ADV TC01. Dog Care WELL-D ADV TC01 5 páginas. Dog training collar

Imprimir página

DogCare WELL-D ADV Dog Training Collar (Model: TC01) FAQ's

1. Can't turn on Remote.

a. Please make sure the remote is charged. Plug the charging cable into the port at the

bottom of the remote and the other end into a working power outlet. Charging should

take about 2 to 3 hours. (It is suggested to charge only for 2 to 3 hours to preserve longer

battery life).

b. After charging twist the knob on the top left of the remote clockwise. The remote should

beep and the screen should light up. The battery level will be indicated by the bars shown

on the battery.

2. Can't turn on the Receiver.

a. Please make sure the Receiver (collar) is charged. Plug the charging cable into the port at

the bottom side of the receiver and the other end into a working power outlet. Charging

should take about 2 to 3 hours. (It is suggested to charge only for 2 to 3 hours to preserve

longer battery life).

Press and hold the ON / OFF button on the top of the Receiver until the collar makes a

double beep and vibrates (press it hard).

3. The Receiver/Collar does not respond.

a. Make sure the receiver and the remote are both charged and have enough power.

b. Make sure the receiver and remote have been paired. (See #6).

c. Check if both units are turned ON.

d. If you have more than one (1) receiver/collar, make sure that the receiver is on the

corresponding channel. (Test the different channels if necessary by changing the channel

with the button on the right and pressing the beep or vibrate button to confirm. Re-pair if

necessary).

e. Press the beep or the vibrate button to test if the receiver is responding. (To test the

shock see #10).

4. The Receiver/Collar is not charging (Battery level for collar shows zero)

a. The remote will display "0 battery" for the receiver when the receiver is OFF. Remember

to always turn ON the Receiver/Collar first and then the Remote Control to see the battery

level.

b. If no signal (beep, vibration or shock) is sent to the Receiver/Collar within 6-8 hours, it will

go into Sleep Mode (the collar will turn OFF). To use the units again, make sure to turn them

ON.

WELL-D ADV

Dog Training Collar

(Model: TC01)