Dog trace d-control 1640 Manual - Página 9

Procurar online ou descarregar pdf Manual para Produtos para animais de estimação Dog trace d-control 1640. Dog trace d-control 1640 18 páginas. Electronic vibration training collar
Também para Dog trace d-control 1640: Manual de instruções (15 páginas)

Imprimir página

SWITCHING THE RECEIVER ON/OFF

A magnet located at the lower part of the transmitter is used to activate or deactivate the magnetic

switch located in the receiver.

Switching on: approach the low area of the transmitter where the magnet is located until coming

close to the indicator located on the receiver (see the picture), hold for 1 second, the receiver

LED indicator will flash in green indicating the receiver is ON.

Switching off: approach the low area of the transmitter where the magnet

is located until coming close to the indicator located on the receiver, hold

for 1 second, the receiver LED indicator will flash from green to red

indicating the receiver is OFF.

To extend the battery life it is necessary to switch off both receiver and

transmitter after the training is finished. If the battery will not be in use for a

month or longer, it is recommended that it is removed from the receiver.

Programming (coding) the transmitter with the receiver

Every remote controller has its own RF operational code. Programming of the remote controller with the

receiver (collar) will be accomplished during the first use of the Dogtrace d-control set or with a new

remote controller or a receiver (when one or the other is lost). This operation will enable you to match

your remote controller to the delivered receiver (collar).

IMPORTANT: Before the programming make sure no other person is using his d-control or other

products from the Dogtrace range close by: your receiver could accidentally record the code of his

transmitter.

Switching ON/OFF the transmitter/Programming the transmitter with the receiver