Clockaudio CW 9000 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Sistema de microfone Clockaudio CW 9000. Clockaudio CW 9000 11 páginas. Uhf ppl wireless microphones

Imprimir página
3.4 CW9001T Belt pack transmitter
A. Microphone input
B. Power On/Off switch
C
C. Antenna
D. LCD display
E. Set button
F. Up button
G. Down button
F
H. Sliding outer cover
G
release buttons
I.
Audio (modulation) level control
J.
Belt clip
K. Battery tray
H
3.5 Lavalier microphone
A. CL6 Lavalier condenser microphone
B. Microphone clip
C. Tini Q 4 pin connector
D. Windshield
C LO C K A U D I O
P A G E 6
B
A
K
D
E
H
I
J
B
D
A
C

4. SETTING UP AND OPERATION

4.1 CW9000R Diversity Receiver
(i) Connect the two antennas to the easy mount
BNC sockets on the rear of the receiver and
align them vertically.
(ii) Insert the DC connector of the power supply
unit in the DCV Input socket on the rear of
the receiver.
(iii) Connect the audio output to a mixer or
amplifier using a lead with an XLR male
connector if it is a balanced connection, or a
lead with a 6.3mm jack plug if it is an
unbalanced connection.
(iv) The electrical supply to the DC power supply
unit can now be made or switched on.
(v) Turn the receiver on by pressing the "Power"
button. (To turn off receiver depress the
"Power" button again)
(vi) To scan or set frequency press the "SET"
button for 3 seconds. Use the "Up" and
"Down" buttons to select the desired frequency
with reference to the LCD display.
(vii) Press the "SET" button again to store the
setting.
(viii)When signal is present audio output level
can be set by using the rotating level control
on the left side of the front panel.
LCD display
A. AF signal level
B. RF signal level
C. Display for scan mode
D. Display for frequency mode
E. Main display
F. Diversity display (antenna 1 or 2)
G. Transmitter battery status
A
B
C
F
E
C LO C K A U D I O
G
D
F
P A G E 7