Akrobat ORBIT INGROUND Manual de instalação e do utilizador - Página 6
Procurar online ou descarregar pdf Manual de instalação e do utilizador para Desporto & Ar livre Akrobat ORBIT INGROUND. Akrobat ORBIT INGROUND 16 páginas. 8 ft, 10 ft, 12 ft, 14 ft
Imprimir página
Digging the trampoline pit
Position the frame on the location you chose and mark the position on the ground. It's best to
3
mark out a hole a bit wider than the diameter of your trampoline.
This will make it easier for you to put the frame exactly above the trampoline pit. Dig the pit to
the following dimensions:
TRAMPOLINE SIZE
Dimension A – Frame diameter
8 ft / cca. 244 cm
10 ft / cca. 305 cm
12 ft / cca. 366 cm
14 ft / cca. 427 cm
The hole should not accumulate water (in which case the drainage is necessary) and it should be
possible to clean during maintenance.
Start digging the hole 15 cm inside from the frame diameter, deepening the pit towards the middle,
where it needs to be 90 cm deep.
AKROBAT HINT:
It's a relatively easy task to hand dig the hole for smaller size trampolines, but it would be best to hire a
mini digger able to excavate most of the soil and leave you with the finishing touches.
Placing the trampoline above the pit
When the hole is dug, place the trampoline
4
above this pit. Make sure the jumping mat is
positioned precisely above the hole.
Fix the legs of the trampoline with the pins. Push
each pin through the hole on the trampoline
leg as shown on the picture. Make sure the pins
are firmly attached to the ground.
6
INSTALLATION AND USER MANUAL - ORBIT INGROUND
Dimension B – Pit diameter
214 cm
274 cm
336 cm
397 cm
Dimension C – Total depth
90 cm
90 cm
90 cm
90 cm