Cymbol G3 Series Manual rápido - Página 5

Procurar online ou descarregar pdf Manual rápido para Câmara de segurança Cymbol G3 Series. Cymbol G3 Series 13 páginas. Network transmitter
Também para Cymbol G3 Series: Manual rápido (16 páginas), Manual rápido (13 páginas), Manual rápido (12 páginas)

Imprimir página

•

Connecting the Power

Connect the DC 12V power adaptor to the camera.

•

Connecting the Wireless using WPS function (wifi model only)

Follow steps for a proper operation.

1. Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected Setup)

functions. WPS enables easy setup with compatible APs.

2. Press the WPS button on the camera board. You can then see the Status LED is blinking.

4. Press and hold down the WPS button on your AP (some router/AP will have a virtual button on

their management software instead). Refer to your AP's documentation for details using its WPS

functions

When WPS configuration is done, wireless connectivity will be established and the security

encryption, such as WEP or WPA-PSK, will be synchronized with the AP.

As for IP setting, the camera's use of DHCP or static IP is determined by your configuration on the

network camera via the web- based configuration of firmware. The camera's default is DHCP.

Notes:

1. WPS may not work if your AP is configured with a "hidden" SSID.

2. If any WPS-enabled AP is not detected, the camera will search APs for 60 seconds after

pressing the WPS button, and if the camera still can not detect an AP after 1 minute, the

wireless setup will be cancelled.

3. If a camera is assigned with a fixed IP outside the AP's network segment, wireless setup will

fail.

4. A wired connection always has a higher priority, and hence wireless setup will not take effect

when the RJ45 LAN port is connected.