Cyndar Electronic Technology HL-1608 Manual do produto - Página 9
Procurar online ou descarregar pdf Manual do produto para Instrumentos de medição Cyndar Electronic Technology HL-1608. Cyndar Electronic Technology HL-1608 14 páginas. Safety edge sensor
Imprimir página
4.Installation instructions
Safety contacts must be installed by the designated person
1. For facilitate installation of edge installation. The mounting
base must be secured to a flat surface. If the safety contact edge
needs to be installed with a certain arc. The radius of the current
curvature shall not be less than a fixed minimum.
2.The mounting base must be fixed with countersunk screws or
rivets. The diameter is 4mm. The nail holes are 4.5mm. They must
be evenly distributed over the entire length of the mounting base.
The hole spacing must not exceed 300mm: the counterbore part
must be processed according to the screw size.
When using a special base, drill a pilot hole in the slot to ensure
that the head of the countersunk screw can pass through (about
8mm).
3.Do not use flat-head or round-head screws. Otherwise, the
connecting wires in the mounting base may be damaged.
4.In order for the connecting wire to pass through the base, an
8mm hole must be drilled in the appropriate position. Carefully
remove the burrs on both sides.
5.
The receiving wire and the end of the cable with terminating
resistor must be placed in the mounting base
6.To make the safety edge easier to install, soapy water should be
sprayed on the mounting base and the safety edge. After the
soapy water evaporates, the safety edge can be firmly fixed on
the aluminum base. In order to avoid sliding after the safety
touch edge, do not use long-lasting lubricants such as talcum
powder and oil.
7.For the safety contact edge with C-shaped base, one side must
be buckled into the installation base. Then press into the entire C-
shaped base. Pushing and pulling the safety contact edge in the
installation base will cause the safety contact edge to damage the
floor. Avoid it anyway.
8.
For the safety contact edge with T-shaped base, it should be
inserted from the side along the groove of the mounting base.
To use other fastening methods. Must be agreed with the
manufacturer in advance.
C-type base
T-type base
9