Dohrmann Enterprises DE-1000 Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Instrumentos de medição Dohrmann Enterprises DE-1000. Dohrmann Enterprises DE-1000 14 páginas. Phase noise analyzer

Imprimir página

DE-1000 Assembly & Installation Directions

7. Attach the discharge bracket so that the discharge tube will be mounted to apply

the product directly into the feed flow (knives and feed roll area). (See figure 3).

Discharge

Bracket

Figure 3

8. Run the discharge tube from the pump, past the flowmeter on the way to the

discharge bracket. Cut the hose at the flowmeter. Loosen the fittings on the

back of the flowmeter. The hose from the pump unit should be inserted into the

bottom flowmeter fitting and the hose to the discharge bracket should be

inserted into the top of the flowmeter, tighten the fittings to secure the hose, (See

Figure 4). Run the rest of the hose from the top of the flowmeter to the discharge

bracket.

9. Find a mounting location for the SP-2 Control Unit. It is recommended that this

be in a location which is within easy reach of the operator. Mount the controller

using the self-tapping screws; drill a 3/16" hole.

10. Connect the power cord to a 12 volt power supply. The RED lead should be

connected to positive (+) and the BLACK should be connected to negative (–).

We suggest taking power direct from the battery or from a 12 volt in-cab

connection. After everything is wired, if the control does not work, it has been

wired in reverse; change the red and black wires at the power source to correct

this problem.

NOTE: Be sure you have good, clean terminals and a good connection. This

system must be connected to a 12 volt system; 6 or 24 volts WILL NOT work.

11. Put water into the tank and run system to make any final adjustments.

FM-1000

Flow Out

Discharge

Flow In

from

Pump

Figure 4