Acquaer SUS075V Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Bomba de água Acquaer SUS075V. Acquaer SUS075V 17 páginas.

Imprimir página

Check pump operation by filling the sump with water and

observing the pump's operation through one complete cycle.

CAUTION: Failure to make this operational check may lead to

improper operation, premature failure, and flooding.

WARNING:

Inspect the work area before each use. Keep work area clean, dry, free of clutter, and well lit. Cluttered,

wet, or dark work areas can result in injury. Using the tool in confined work areas may put you

dangerously close to other cutting tools and rotating parts.

Check for damaged parts before each use. Carefully check that the pump will operate properly and

perform its intended function. Replace damaged or worn parts immediately. Never operate the pump

with a damaged part.

Do not use the pump where there is a risk of causing a fire or an explosion; e.g., in the presence of

flammable liquids, gases, or dust. The tool can create sparks, which may ignite the dust or fumes.

Keep children and bystanders away from the work area while operating the pump. Do not allow children

to handle the pump.

Be aware of all power lines, electrical circuits, water pipes, and other mechanical hazards in your work

area. Some of these hazards may be below the work surface hidden from your view and may cause

personal harm or property damage if unintentionally contacted.

WARNING: Do not disassemble the motor housing. This motor has NO repairable internal parts, and

disassembling may cause an oil leak or dangerous electrical wiring issues.

Problem

Pump does not

start or run

Pump operates

but pumps little

or no water

INSTALLATION INSTRUCTIONS

TROUBLESHOOTING

Possible Cause

1.Blown fuse

2.Tripped breaker

3.Plug disconnected

4.Corroded plug

5.Thermal overload

6.Motor failed

1.Pump screen or screen cover blocked

2.Impeller loose on shaft

3.Impeller broken

4.Pipe or hose loose.

Corrective Action

1.Replace fuse

2.Reset breaker

3.Secure plug

4.Clean plug prongs

5.Disconnect the pump from power

for 30 minutes, then reconnect

6.Contact customer service for

replacement

1.Clean screen

2.Reassemble impeller

3.Contact customer service for

replacement

4.Secure pipe or hose