Akron 3462 Instruções de instalação, funcionamento e manutenção - Página 3
Procurar online ou descarregar pdf Instruções de instalação, funcionamento e manutenção para Instrumentos de medição Akron 3462. Akron 3462 18 páginas. Forestry bumper monitor
Também para Akron 3462: Manual de instruções (17 páginas)
Imprimir páginaINSTALLATION, OPERATING and MAINTENANCE INSTRUCTIONS
The following is intended to provide the basic instructions for installation, operating and maintenance of
the 3462 forestry Bumper Monitor .
PRODUCT RATINGS
Maximum motor current draw:
12 volt versions
50 amps each for elevation and rotation motors (Locked rotor current)
24 volt versions 25 amps each for elevation and rotation motors (Locked rotor current)
Normal operating current (depending on operating conditions - pressure, flow, etc . ) :
12 volt versions
3 - 10 amps each for elevation and rotation motors
24 volt versions
Minimum Voltage: (Truck engine must be operating for proper voltage requirement.)
All 12 volt motors: 11 . 5 volts while operating
All 24 volt motors: 23 volts while operating
Mass: 23 lbs . (10 . 4 kg) with out nozzle or quick disconnect base
Maximum Flow: 300 GPM (1135 lpm)
Maximum Pressure: 200 PSI (14 bar)
Noise Emission: 94 Db@ 1m with Maximum Flow
PRODUCT WARNINGS
WARNING:
The maximum flow of the Bumper Monitor is 300 GPM . The center of the waterway outlet is 13
inches from the bottom of the inlet . Ensure these values and an appropriate safety factor is used to de-
termine a proper support structure .
WARNING:
Aim the Bumper Monitor in a safe direction before pumping water through it .
WARNING:
The Bumper Monitor uses current limiting for both the monitor and nozzle stops . Use only appropriate
Akron Brass nozzles .
WARNING:
Do not use the electric controls when the override cranks are being used or are in position for use .
WARNING:
If any tags or bands are worn or damaged and cannot be easily read, they should be replaced .
WARNING:
Disconnect power and disable flow before maintenance .
WARNING:
Keep all personnel out of the Danger Zone (in front of the outlet of the monitor) when the water
source is attached . Dangerous flow velocities can cause serious injury .
STYLE 3462 FORESTRY BUMPER MONITOR
3 . 0 amps for nozzle pattern motor
1 . 5 amps for nozzle pattern motor
0 . 7 amps for nozzle pattern motor
2 - 5 amps each for elevation and rotation motors
0 . 4 amps for nozzle pattern motor
122386
/
"
3
16