Dolby Laboratories CP750 Manual de instalação - Página 8

Procurar online ou descarregar pdf Manual de instalação para Hardware informático Dolby Laboratories CP750. Dolby Laboratories CP750 19 páginas. 7.1 audio for the dolby multichannel amplifier

Dolby Laboratories CP750 Manual de instalação

3 Setting up the system

To use the CP750 (or other cinema processor) with a Dolby Multichannel Amplifier, you need to
set up and connect all of the required hardware and configure the system.

Setting up the Yamaha Tio1608-D

Interconnecting the hardware
Using the Dante controller for the AES67 setup
Setting up the Dolby Multichannel Amplifier
Configuring advanced connections
3.1 Setting up the Yamaha Tio1608-D
You need to perform an initial setup of the Yamaha Tio1608‑D.
Prerequisites
Download and install the latest Dante Controller software for your computer. This application
enables you to configure the inputs and outputs for use with a Dolby Multichannel Amplifier.
For additional details, see the
Controller User Guide , which are shipped with the Yamaha Tio1608-D.
To download the Dante Controller software, you must first open an account with Audinate (free)
and then download the software at
controller.
In some rare situations, you may need to set a static IP address on the Yamaha device. To do
this, you can use the Yamaha R-Remote software, which you can download at
www.yamahaproaudio.com/europe/en_gb/downloads/firmware_software/tio1608d/.
About this task
You use the YamahaTio1608‑D rear panel to:
Connect the unit to the network using the Primary R-J45 port
Configure the dip switches
Connect power
You use the YamahaTio1608‑D front panel to:
Make additional settings
Connect audio from the CP750
Turn the unit on
The following figures show the Yamaha Tio1608‑D front and rear panels.
Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual
7 May 2018 Issue 1
Yamaha Tio1608-D Owner's Manual and the Audinate Dante
https://www.audinate.com/products/software/dante-
Setting up the system
http://
8