CYP CH-1529RXV Manual de operação - Página 9

Procurar online ou descarregar pdf Manual de operação para Recetor CYP CH-1529RXV. CYP CH-1529RXV 20 páginas. 4k uhd+ hdmi over hdbaset receiver with hdr & oar

Imprimir página

SERVICE: This USB port is reserved for firmware update.

RS-232: Connect to a PC, laptop or other serial control device

with a 3-pin adapter cable for the extension of RS-232 signals to

the Transmitter in "Bypass" mode, or for control this unit when in

"Console" mode.

Note: Depending on the controlled device connected to the

Transmitter side, the Tx and Rx pins might need to be reversed.

CONSOLE/BYPASS: This switch controls the operational mode of the

RS-232 port. When set to "Bypass", RS-232 signals will be passed to

the connected Transmitter. When set to "Console" the RS-232 port

may be used to send commands directly to the Receiver.

Note: RS-232 bypass requires both the Transmitter and Receiver to

be set to "Bypass" mode.

6.2 Rear Panel

LAN: Connect to an Ethernet supporting device or to your local

network, as appropriate, to extend the network to both ends of

the HDBaseT connection.

HQ & STD LEDs: These LEDs illuminate to indicate which AVLC mode

will be used when AVLC is required. The lower green LED indicates

that AVLC will use HQ (High Quality) mode. The upper yellow LED

indicates that AVLC will use STD (Standard) mode.

HDMI OUT: Connect to an HDMI TV, monitor or amplifier for digital

video and audio output.

CAT5e/6/7 IN: Connect to a compatible, 48V PoH supplying,

HDBaseT Transmitter with a single Cat.5e/6/7 cable for transmission

of all data signals as well as to power the unit.