CYP CH-1527RX Manual de operação - Página 8
Procurar online ou descarregar pdf Manual de operação para Extensor CYP CH-1527RX. CYP CH-1527RX 16 páginas.
Imprimir página
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
IR1
BLASTER
IR2
DC 48V
EXTENDER
1
2
3
DC 48V: Plug the 48V DC power supply into the unit and connect
1
the adaptor to an AC outlet.
IR1 BLASTER: Connect to the supplied IR Blaster cable for IR signal
2
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
3
IR2 EXTENDER: Connect to the supplied IR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
CAT5e/6/7 OUT: Connect to the Receiver unit with a single
4
CAT5e/6/7 cable for transmission of all data signals.
5
HDMI IN: Connect to HDMI source equipment such as a DVD or
Blu-ray player.
STD/UPDATE Switch: This switch is reserved for factory use only.
6
RS-232 IN: Connect to a PC or Laptop with D-Sub 9-pin male cable
7
for the transmission of RS-232 commands.
LAN: Connect to an internet or network system.
8
POWER LED: This LED will illuminate when the device is connected
9
to a power supply.
LINK LED: This LED will illuminate when both Transmitter and Receiver
10
are connected through CAT cable. When it blinks regularly it
states the Transmitter is NOT sending signal but the Transmitter and
Receiver are linked and if it blinks irregularly it states an error has
occurred.
3
HDMI IN
4
5
Rear
RS-232 IN
STD UPDATE
6
7
POWER
LINK
8
9
10