Ashford Jack Loom Manual de instruções - Página 11

Procurar online ou descarregar pdf Manual de instruções para Rodas giratórias Ashford Jack Loom. Ashford Jack Loom 16 páginas.

Imprimir página

17. Lift the wooden spacer P from the castle E to allow

the warp roller Z to fit between the uprights without

twisting them. Then place the warp roller between the

back uprights C and CX by locating the shaft of the

warp roller into the nylon bush in CX. Secure the warp

roller by tapping a 5/8 x 75 Steel Shaft through the

nylon bush in C and into Z.

18. Fully thread two screw hooks into the brake lever W and

one screw hook into the hole underneath FX.

19. Push a

M6 x 65 Cup Head Bolt

and tap the head into the wood with a hammer. Place

the brake lever W, a

M6 X 16 Washer

onto the bolt. Don't overtighten as the brake

Nylock Nut

lever must move freely.

M6 x 40

Cup Head Bolt

TAP IN WITH

A HAMMER

20. Push the

M6 x 40 Cup Head Bolt

Washer,

Brass Spacer M11 x 4

Adjust the screw hooks in the turnbuckle until they are both in the middle of their thread range. Wind the cable around the

brake drum 4 times in the direction illustrated starting with the cable closest to the upright CX and attach the turnbuckle to

the screw hook at the end of the brake lever W.

21. Locate the spring between the screw hooks in FX and brake lever W.

NOTE: If the brake does not easily release check the following:

a) That the wire rope is wound evenly on the brake drum and is not crossed over.

b) That the wire cable has been wound in the correct direction.

c) Adjust the turnbuckle until the cable grips the brake drum but releases when the brake lever is depressed.

through the castle side EX

and then a

M6 X 16

Washer

M6 X 16 Washer

through the upright CX and tap the head into the wood with a hammer. Then locate a M6 x 16

, the loop of the brake cable,

M6 Nyloc Nut

M6 x 65 Cup Head Bolt

and

M6 X 16 Washer

M6 X 16

Washer

M6 Nylock

Nut

onto the bolt and tighten firmly.

M6 Nylock Nut