Ashford Jack Loom Manual de instruções - Página 14
Procurar online ou descarregar pdf Manual de instruções para Rodas giratórias Ashford Jack Loom. Ashford Jack Loom 16 páginas.
Imprimir página
M6 Barrel Nut
(Hidden)
M6 x 16 Washer
M6 x 65 Hex Head Bolt
32. NOTE: There are 8 parallel lams and 10
treadles with 8 holes in each treadle.
There are 80 cords, 10 for every lam.
Thread all the cords through all the holes
in the lamms. Then after determining the
pattern connect the cord to the hole in
the treadle directly beneath it.
Do this by feeding a 30cm piece of
Texsolv cord through a hole in a lam and
loop it through itself. Then feed it down
through the corresponding hole in a
treadle and secure with a Texsolv peg.
Hint: It may be more convenient to do
this after carefully tipping the loom onto
its front.
TAP IN WITH
A HAMMER
M6 x 75 Cup Head Bolt
M6 x 22 Washer
M16 Rubber
Buffer
6 x ½ Pan
Head Screw
M6 Nylock Nut
M6 x 16 Washer
28. Tap the beater stops into the castle
29. Assemble the beater by joining the sides
30. Place the reed into the groove in the
31. Place the beater in position on the loom
M6 x 16 Washer
M6 x 100
Hex Head Bolt
Texsolv peg
14
sides E and EX. Note the lead holes for
the screws face out. Use wood glue if
necessary. They should project approx.
70mm (2¾"). Then attach the
to the stops with
Buffer
6 x ½ Pan Head
.
Screws
Q to the bottom rail R with
,
Head Bolts
M6 X 16 Washers
. Note the shuttle race faces forward.
Nut
bottom rail R. Secure the top beater rail
S to the sides with
M6 x 75 Cup Head Bolts
and nylon knobs. Tap
M6 x 22 Washers
the head of the bolt into the wood with a
hammer.
frame and push a
M6 x 100 Hex Head Bolt
and
through the beater
M6 X 16 Washer
side Q, through the hole in the spacer
block attached to the side A and secure
with
and
M6 X 16 Washer
M6 Nylock Nut
Repeat for side AX
NOTE: Do not tighten bolts, the beater
must move freely.
M16 Rubber
M6 x 65 Hex
and
M6 Barrel
,
.