CYP CPRO-8ER Manual de operação - Página 8

Procurar online ou descarregar pdf Manual de operação para Cabos e conectores CYP CPRO-8ER. CYP CPRO-8ER 12 páginas. 4kx2k 1 by 8 hdmi splitter
Também para CYP CPRO-8ER: Manual de operação (12 páginas)

Imprimir página

6.2 Rear Panel

HDMI IN

SYS

RESET

EDID

SERVICE

OFF

STD

SYS RESET ON/OFF: When switched ON (default setting is off) the

unit will, every 8~10 minutes, automatically switch all connected

displays to their HDMI Input 1.

Note: For this feature to function connected displays must support

CEC commands.

EDID STD: When in 'STD' mode, the unit will use its own built-in EDID

settings. In this mode, the video output will be set to 1080p@60Hz

and the audio output at LPCM 2CH Stereo. Use this mode if there

are display problems in TV Mode.

EDID TV: When in 'TV' mode, the unit will read the EDID settings of

the display device connected to HDMI OUT 1. If it detects a 4K2K

capable EDID setting it will transmit the signal in that format to

all outputs. If no 4K2K capable EDID is detected then the unit will

output the best resolution that all displays can support.

Note: The unit will retain and use the EDID settings of the last device

connected to the HDMI OUT 1 output if no device is connected to

this output even after switching EDID modes or a power cycle.

SERVICE: Manufacturer use only.

HDMI IN: Connect the input port to the HDMI or DVI output of your

source device such as a DVD player or set-top box with an HDMI

cable.

HDMI OUT 1~8: Connect each of the HDMI outputs to an HDMI

display for simultaneous HDMI distribution, or cascade the output

to another transmitter to extend the operating distance.

DC 5V: Plug the 5V DC power supply into the unit and connected

the adaptor to an AC outlet.

HDMI OUT

DC 5V