Ashland PED33CI Funcionamento, desempenho e especificações - Página 5

Procurar online ou descarregar pdf Funcionamento, desempenho e especificações para Bomba de água Ashland PED33CI. Ashland PED33CI 8 páginas. Pedestal sump pumps, thermoplastic/cast iron/bronze

Imprimir página

Do not work on pump until power is unplugged.

Do not cut off ground pin or use an adapter fitting.

Do not use an extension cord.

The pump power cord should be connected to a

separately fused, grounded line with a minimum

capacity of 15 amps. It can be connected to non-fuse

breaker at the recommended amperes.

1. Before installing or servicing this pump, be

certain pump source is disconnected.

2. Installation and electrical wiring must adhere

to state and local codes and must be completed

before priming pump. Check appropriate commu

nity agencies, or contact local electrical and pump

professionals.

3. Call an electrician when in doubt. Pump should be

connected to a separate 15 amp circuit breaker

or 15 amp fuse block.

Note that plugging into existing outlets may cause

low voltage at motor. This could cause blown fuses,

tripping of motor overload or burned out motor.

4. A permanent ground connection from pump to the

grounding bar at the service panel is mandatory.

These sump pumps come with a grounding conduc

tor and a grounding-type attachment plug. Do

not connect pump to a power supply until perma-

nently grounded. For maximum safety, connect

pump to a circuit equipped with a fault interrupter

device when positioning the pump's grounding wire.

5. Voltage of power supply must match the voltage of

the pump.

6. Before installing pump, clear sump basin of any

water, debris or sediment.

Sump basin must be vented

in accordance with local plumb-

ing codes. These Sump pumps are not designed for

and CANNOT be installed in locations classified as

hazardous.

7. The following may cause severe damage to pump

and will void the warranty.

(a) Using an extension cord.

(b) Cutting off the ground pin or using an adapter

fitting.

(d) Removing motor housing, unscrewing

impeller, or otherwise removing impeller seal.

(e) Running the pump continuously.

(f) Pumping chemicals or corrosive liquids.

(g) Pumping gasoline or other flammable liquids

Pedestal Pumps

Models: PED Series

Installation

8. Plastic PVC pipe can be installed in the outlet pip

ing. Drain hose, galvanized steel or copper pipe

may be used if desired. All piping must be clean

and free of all foreign matter to prevent clogging.

9. Pump will be inadequate if suspension liquids con-

tain solid particles larger than 3/16" for EPP or 3/8"

for EPC.

ELECTRICAL WIRE CONNECTION

on the nameplate corresponds to those available on

the mains. The installer must make sure that the

electric system is grounded in accordance with code.

• For outdoor use it is necessary to use cable with a

length of at least 8'. The plug and connection

should be protected from water splashes. Before

using the pump, always in spect it visually

(especially power cable and plug).

• Do not use pump if it is damaged

• If the pump is damaged, have it inspected by an

authorized service center.

• Make sure that electric connections are pro

tected from flooding. Protect the plug and the

power cable from heat or shape edges.

only. Grounding: The plug of the power cable has a

double grounding contact, so that grounding can be

performed by simply inserting the plug.

OVERLOAD PROTECTION

This pump series has a built in thermal protection

switch. The pump stops if an overload condition

occurs. The motor restarts automatically after it has

cooled down.

Verify that the voltage and

frequency of the pump shown

The power cable must be re

placed by qualified personnel