Cypress CY3655 Manual do utilizador de hardware - Página 14

Procurar online ou descarregar pdf Manual do utilizador de hardware para Microcontroladores Cypress CY3655. Cypress CY3655 17 páginas.

Other Kit Hardware

Overview

This section describes the rest of the hardware components that are part of the Cypress

enCoRe II DVK.

5-Pin to USB Adapter

The 5-Pin to USB adapter is a small board that allows enCoRe II based devices to be

programmed through their USB cables using the MiniProg (sold separately). This adapter is

not designed to be used with the ICE-Cube and ISSP cable due to cable length restrictions

during programming. The steps below describe the programming procedure using the

MiniProg.

1. Using a USB cable, plug the MiniProg programmer into a PC that has the PSoC

Programmer application installed.

2. Connect the 5-pin to USB adapter to the MiniProg programmer. It will only attach in one

orientation.

3. Connect the USB end of the 5-pin to USB adapter to the USB cable of a device that

uses enCoRe II. Note that the USB device must have a cable no longer than 1 meter.

Typical target devices are mice and keyboards.

4. Launch the PSoC Programmer application.

5. In the programming application, select the Port as the MiniProg. After selecting the

MiniProg, make sure that in the "Results" column of the window that an unexpected

firmware version was not found. If necessary, update the MiniProg's firmware by

choosing "Upgrade Firmware" in the "Utilities" menu.

6. First select the appropriate device family then select the device to be programmed.

7. Load the programming file using the "File Load" button.

8. Program.

CY3655 Hardware User Guide

Page 14 of 16