Ashly MX-206 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Misturador de música Ashly MX-206. Ashly MX-206 8 páginas. Stereo microphone mixer
Também para Ashly MX-206: Manual de instruções (12 páginas), Notas técnicas e especificações (2 páginas), Manual de instruções (9 páginas), Manual de instruções (12 páginas)

Imprimir página

Operating Manual -MX-206 Stereo Microphone Mixer

4.5 Stereo Line In

This control adjusts the level of the stereo line in

signal from the RCA inputs on the back panel and the

3.5mm Stereo Line In jack on the front panel. The Stereo

Line In input signal should have a nominal level of -10dB.

4.6 Stereo Outputs

The Left and Right output levels are independently

controlled by these two dials. They respectively determine

the signal at the 1/4" jack Main outputs.

4.7 Mono Output

This inner concentric control determines the out-

put level of the transformer-balanced Mono Output XLR

connector. Its signal is summed from the right and left

mix bus, and is fully independent of the settings of the

stereo output level controls.

4.8 Headphones Output Level

This outer concentric control determines the level

of the stereo headphones, and is fully independent of the

settings of the stereo and mono output level controls

4.9 Output Meters

Two 6-segment LED arrays show the current sta-

tus of the stereo outputs. 0VU is equivalent to +4dBu

(1.228Vrms).

4.10 Stereo Headphone Jack

You can monitor the stereo mix through head-

phones independent of all other output controls. In other

words, the headphones can be used even if all other out-

put controls are turned off.

4.11 Phantom Power Indicator

This red LED is lit when the +48V phantom power

is turned on. The phantom power switch is on the back

panel.

4.12 Power Switch

This switch turns on AC power to the mixer, light-

ing the green LED. If the switch is pressed but the LED is

still off, check to see that the AC power cord is not de-

tached.

5. CONNECTIONS AND CABLES

The MX-206 mixer is fitted with five types of au-

dio connectors: 3-pin XLR type male (mono output), 3-

pin XLR type female (mic inputs), tip-ring-sleeve (TRS)

phone jacks, RCA jack, and 3.5mm stereo TRS jack. Al-

though using unbalanced tip-sleeve 1/4" plugs will work

in certain applications, we recommend always using bal-

anced TRS cabling for the stereo 1/4" jack outputs.

3.5mm Stereo Phone Plug

used for Stereo Line In

Tip (L), Ring (R)

Tip (+)

Ring (-)

Sleeve (Gnd)

Tip (+)

Sleeve (Gnd)

XLR pins are

numbered

on the

connector

insert.

2 = (+)

3 = (-)

1 = (gnd)

Audio Connector Types

(Gnd)

(+)

RCA Plug

Stereo Phone Plug

used for balanced

Mono Phone Plug

used for unbalanced

XLR Male

XLR Female