Ashly RW-8C Manual do produto - Página 2

Procurar online ou descarregar pdf Manual do produto para Controlo remoto Ashly RW-8C. Ashly RW-8C 4 páginas. Remote level control
Também para Ashly RW-8C: Brochura e especificações (2 páginas), Manual de início rápido (4 páginas)

Imprimir página

Introduction: The RD-8C and RW-8C are remote level con-

trollers which can be used with the VCM-88C, Protea 24.24M, and

certain future Ashly products. The RD-8C is a desktop controller,

while the RW-8C is electronically the same but mounts as a wall

plate using a standard 4-gang electrical box. There are eight chan-

nels and a master, each with a level control and an on/off button.

The Remote Disabled LED indicates when the RD/RW-8C has been

disabled from the VCM-88C front panel switch. Note: The Remote

Disabled LED will illuminate when the VCM-88C Remote Disable

switch is pushed in, and communication will be inhibited.

Used with the VCM-88C, the RD/RW-8C offers a direct cor-

relation of remote faders to VCM-88C channels, as well as its master

fader. Connect the RD-8C or RW-8C to a VCM-88C as follows:

Channel 1 on a RD/RW-8C will always control channel 1 on

the VCM-88C, and likewise channels 2-8 and the master will each

control their respective VCM-88C channel. The data output signal

may be "split" in order to feed two VCM-88C units to give stereo 8-

channel capability.

Used with the Protea 24.24M DSP Matrix Processor, and

using Protea System Software version 6.4 or higher, each RD/RW-

8C slide fader can be assigned to attenuate any 24.24M input, out-

put, or input/output combination, limited only by the number of avail-

able 24.24M channels. Only one RD/RW-8C can be used per 24.24M.

Connect the RD-8C or RW-8C to a 24.24M as follows:

The remote will not function simultaneously with any other

serial communications device connected to the 24.24M at the same

time. The software programming needs to be done before connect-

ing the remote. After the 24.24M is programmed for the desired RD-

8C fader assignments, the computer must be disconnected from the