Ashly Protea WR-5 Manual de instruções

Procurar online ou descarregar pdf Manual de instruções para Hardware informático Ashly Protea WR-5. Ashly Protea WR-5 4 páginas. Ne product remote control
Também para Ashly Protea WR-5: Nota de lançamento (1 páginas), Manual de instruções (6 páginas)

Imprimir página

Operating Manual - WR-5 Remote Control

1. Introduction:

The WR-5 is a microprocessor based remote control unit for the Protea 24.24M, Ashly's multi-

channel DSP matrix processor. The WR-5 is designed to fit into a standard electrical wall box for

remote control of assignable 24.24M functions. Each of six buttons on the WR-5 can be pro-

grammed to engage one of the following functions: preset recall/scroll, channel volume, mute, or

zone source selection. Programming of each button is done from software, when the WR-5 is con-

nected to its host 24.24M, and the 24.24M is in turn connected to a PC using Protea System Software

(version 6.4 or greater). Multiple WR-5 units can be daisy-chained from the same 24.24M for

discrete control over multiple locations under the processing control of one 24.24M.

Installations which currently use WR-3 or WR-4 units can integrate a WR-5, but special wiring

requirements apply (see section 3). For new installations, Ashly recommends exclusive use of the

WR-5.

2. WR-5 Features:

The WR-5 can be thought of

primarily as a programmable zone

controller. The physical acoustic space

in which one WR-5 is installed is gener-

ally considered one zone, driven by a

24.24M output or group of outputs.

The WR-5 has six programmable

buttons, each with its own status LED.

Button programming is done in Protea

System Software (V6.4 or higher).

There is a pocket in the mylar overlay to

the right of each button for a paper label

to be inserted. The two up/down buttons

adjust overall zone volume level (if

programmed) or individual button

parameters. The numeric LED displays

zone volume level, button/function

values, or status/diagnostic indicators.

On the back of the WR-5 unit, two four pin euroblock connectors are used for data INPUT from

a 24.24M, or LINK for connecting to another WR-5. There is also a two pin jumper labelled "J6"

which requires the provided female jumper to be installed if the WR-5 is the last one in the data

chain.

3. Wiring and Mounting a WR-5:

All wire connections between a WR-5 and the 24.24M use a two-piece euroblock connectors, a

screw-terminal plug for the wire connections, and the mating jack on the product itself.

WR-5 User Reference

ASHLY WR-5