Dolphin DXS410 Manual de início rápido - Página 5
Procurar online ou descarregar pdf Manual de início rápido para Interruptor Dolphin DXS410. Dolphin DXS410 7 páginas. Dolphin switch quick start guide
Imprimir página1.3 Software Required
The DXS410 DX Switch can be used in a number of applications. Dolphin provides
specific application software to support these various applications. This software is nec-
essary to use the DXS410. Application software can be downloaded from the Dolphin
website at http://www.dolphinics.com/support/. Software installation instruction can be
found on the Dolphin website.
1.4 Hardware Installation Procedure
1. Remove the chassis from the box
2. Connect main power (100-240VAC) using the provided AC power cord or a region-
ally appropriate AC power cord to the DXS410 power connector, which is located
on the front of the chassis see Figure 1–1. The power supply will accept any voltage
from 100V to 240VAC at frequency of 50-60Hz.
Figure 1–1 AC Power Inlet
3. Turn on the AC power switch on the front of the DXS410. This will apply AC
power to the chassis.
4. The DXS410 switch will go through a self test. You will observe that for 0.5 sec-
onds the 10 Port LEDs turn green and that the red alarm LED along with the green
power LED turn on. Then for 0.5 seconds, the 10 Port LEDs turn yellow while the
other 2 LEDs stay on. The 10 Port LEDs and the Alarm LED will then turn off
while the power LED is kept on.
5. Insert one or more cables into the connectors on the front of the switch box. The
connectors are labeled for x4 or x8 operation as show in Figure 1–2.
April 2008
Installation
2