ASI 20200 Manual do utilizador - Página 2
Procurar online ou descarregar pdf Manual do utilizador para Secador ASI 20200. ASI 20200 4 páginas. Roval collection tri-umph high-speed hand dryer
Imprimir página™
ROVAL
COLLECTION TRI-UMPH™ HIGH-SPEED HAND DRYER (PAGE 2 OF 4)
INSTALLATION
Mount unit cabinet on wall with eight (8) № 10 x 1-1/4" (M5) pan head screws (supplied) through wall plate
(provided) into plastic anchors (supplied) or other suitably prepared mountings (by others) or other suitable
mounting hardware (by others) to suit wall conditions. Electrical service (see rating per model; provided by others)
is either provided to duplex outlet in wall adjacent to unit mounting location or brought to KO location for dryer
indicated on diagram prior to installation of unit. Electrical service is supplied and connected (by others) in
accordance with schematic and Owner's Manual provided with unit prior to installing access drawer. Cabinet is
secured first to wall plate with
drawer is secured also with
ICC/ANSI A-117.1 and 2010 ADA Accessibility Standards install unit with top of dryer hand chamber less than
46-3/4" [1187] above finished floor (MAX AFF). For general utility install unit so that top of dryer hand chamber
is 44" to 50" [1118 to 1270] AFF.
on center. See OM & IG for additional mounting heights for age specific sites.
OPERATION
User activates dryer by placing hands into open hand chamber. LED's change color from amber ready-status to
soothing blue to indicate operation. Directional air jets from top blow water droplets off hands onto evaporator
plate. Dryer automatically shuts off after time-out (Hold-On) when user removes hands from sensor zone or after
60 seconds if unit is purposefully kept operating for longer than normal drying time (e.g. washroom
experimentation, vandalism). Owner may choose to set heater on or off with concealed switch for increased
economy based upon 900 Watt operating reduction or may choose to vary/reduce heat output with concealed
control between 400 Watts and 900 Watts for user comfort level. Evaporator plate allows atomized droplets to
return to vapor state without dripping on floor or back wall behind and below unit. Drip tray prevents excessive
waste water from draining onto floor under unit in very heavy usage settings or in high-humidity environments.
Security locking screw concealed under filter access drawer prevents unauthorized tampering and protects asset.
Triple-Filter element removes airborne solid particles and is changed manually by owner on cycle determined by
maintenance requirements. Replacement filters are available from ASI either in carton quantities or in single units.
Motor brushes will require replacement under normal intermittent usage conditions approximately every three to
four (3~4) years. Complete operating instructions and maintenance information is provided in OM & IG provided
with unit.
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701
(914) 476.9000 • (914) 476.0688
www.americanspecialties.com
a concealed pin-hex socket pan head security screw
a concealed pin-hex socket pan head security screw
For installation of two or more dryers, units should be no closer than 24" [610]
MODEL №:
20200/20201
ISSUED:
06/12
REVISED:
10 MAY 2017
(supplied) and then filter
(supplied). For compliance with