BlueParrott S450-XT Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Auscultadores BlueParrott S450-XT. BlueParrott S450-XT 16 páginas.

GETTING STARTED

Power S450-XT On/Off (Bluetooth Mode)

On: Slide the switch up toward the headband. The LED will flash blue three times and you will hear a

voice prompt, "Power on." If your S450-XT is not already paired with a device, it will automatically go into

pairing mode; otherwise, it will attempt to connect with its paired device(s).

Off (conserves battery power): Slide the switch down from the headband. The LED will flash red four

times and you will hear a voice prompt, "Power off."

Standby Mode: Once the S450-XT is turned on (after the initial pairing), it will attempt to connect to the

last device that it was paired with, putting itself into Standby Mode.

1. Confirm that your cell phone supports NFC pairing.

2. Make sure that NFC is enabled on your cell phone.

3. Turn the S450-XT on.

4. Place the NFC zone of your cell phone against the NFC

zone of the S450-XT and hold together while your cell

phone registers the headset.

5. Follow the prompts on your cell phone until it confirms

pairing is successful.

Note: NFC and one-touch pairing are dependent on your cell

phone. The size and sensitivity of your phone's NFC zone and

how to connect the headset may vary between devices.

VXi BlueParrott

S450-XT User Guide

NFC Zone

PAGE 7