BluePoint Fasteners GT-100L Manual de Segurança e Operação - Página 11

Procurar online ou descarregar pdf Manual de Segurança e Operação para Pistola de pregos BluePoint Fasteners GT-100L. BluePoint Fasteners GT-100L 13 páginas. Gas concrete nailer

Imprimir página

Operator troubleshooting

PROBLEM

CHECK METHOD

Check for jammed nails.

Nailer operates,

but no nail is driven.

Check for proper nails.

Check for a jam .

Check function of nail feeder .

Ribbon spring weakened

or damaged?

Check if the driver blade

piston is down or not.

Check for proper nails.

Skipping nails.

Intermittent feed.

Check function of nail feeder.

spring weakened or damaged.

Ribbon

Nail feeder weakened or damaged?

Check for returning of piston.

Check for moving of pistonsmoothly.

Nail jam.

Check for proper nails.

Driven nail is bent.

Driver blade worn?

Nail feeder worn or damaged?

The operation of the

firing head bent?

firing head

not smooth.

Check firing head's moving track,debris? Clean the foreign body.

Fan is working, light indicator

Check for returning of piston.

shows GREEN yet it doesn't

drive a nail or operation

unstable.

Check fuel cell, insufficient?

Check spark plug wire, worn out?

Check high pressure cap joint insert

to the spark plug.

Check spark plug, grease ordebris?

Check filter, clogged?

Fan does not operate

Magazine empty.

when firing head is pressed.

Note the color of the light indicator.

Inspect if the battery temperature is within

Unable to charge battery

requiredrange50°F(10°C)～104°F(40°C).

or red light blink.

Check if all joints are inserted and

the battery pack is inserted in place.

Utility voltage not nearly of rated

voltages shown on adapter nameplate.

CORRECTION

Clear jammed nails.

Use only recommended nails.

Clear a jam.

Clean and lubricate.

Replace Ribbon spring.

Push the driver blade with a

slotted-head screwdriver, and put

back the piston to the highest position.

Use only recommended nails.

Clean and lubricate.

Replace

spring.

Ribbon

Replace nail feeder.

Too low temperature, warm up

fuel cell under 50℃(120℉).

Replace piston assembly.

Use only recommended nails.

Replace piston assembly.

Replace nail feeder.

Replace firing head.

Pull the trigger all the way.

Too low temperature, warm up

fuel cell under 50℃(120℉).

Exchange it with a new fuel cell.

Contact dealer for replacement

High pressure cap joint insert

to the spark plug.

Clean the foreign body.

Cleaning or Contact dealer for

replacement.

Load more nails(more than 3 nails)

in the magazine.

If red: charge the battery.

If green:Contactdealerforreplacement.

Wait the battery temperature as

the normal range then to charge.

nsert all plugs and ensure the

battery pack insert in place.

Select and use correct utility voltage to

charge. If also can not charge,contact

dealer for replacement.