Blueprint Subsea Seatrac x110 Upgrade Manual - Página 4
Procurar online ou descarregar pdf Upgrade Manual para Sistema de segurança Blueprint Subsea Seatrac x110. Blueprint Subsea Seatrac x110 10 páginas. Upgrading beacon firmware
2.2. Programming New Firmware
For beacons to function and communicate correctly, each SeaTrac beacon should be programmed to the
firmware release using the following procedure...
•
If you haven't already done so, connect the SeaTrac beacon to the serial port of a PC (or use the USB-
to-Serial converter supplied with the SeaTrac system).
•
Power up the SeaTrac beacon and run the SeaTracProgrammer program (either from the Start Menu,
or by executing "SeaTracProgrammer.exe").
•
In the application window, click the drop-down list to choose the COM port the beacon is connected to
(), then choose a baud rate of 115200 from the second drop down list (). Finally click "CONNECT" to
connect to the SeaTrac beacon ()...
•
Having opened the serial connection, check the SeaTrac Beacon is connected and get is hardware
information by clicking the "INFO" button ().
•
If the beacon isn't connected properly, you will see something similar to...
Device identifying...
Timed out waiting for device to reply.
Aborted.
•
However, if the serial communication settings are correct, you will see information similar to...
Device identifying...
Device information...
Uptime = 4238 seconds
Run Section = APPLICATION (1)
Hardware Part Number = BP00795
Hardware Revision = 6
Hardware Serial Number = 001234
Hardware Flags = 0x00000000
Bootloader Valid = True
Bootloader Part Number = BP00912
Bootloader Version = v1.6.436
Bootloader Checksum = 0x00000000
Upgrading Beacon Firmware
SeaTrac
4